BRIGHT 023700 Instructions D'origine page 19

TECHNICAL DATA
Rated voltage
Output
Capacity
Dimensions
NOTE:
Vacuum bags sold separately.
PARTS LIST
1. Plastic lid
2. Viewing window
3. Control panel and control unit
4. Display
5. Lid handle
6. Side handles
7. Robust stainless steel body
8. MIN water level mark
9. MAX water level mark
10. Bag rack
FIG. 1
DISPLAY FUNCTIONS
• TIME
Button to set cooking time 0–99.59
hours. When the product is in standby
mode, press once to set the hour, press
once again to set the minutes.
• Temp
Button to set cooking temperature
0–90°C. When the product is in standby
mode, press once to set the temperature
in °C, press once again to set it in °F.
• +/-
Button to increase or decrease time or
temperature settings.
• START/STOP
Start/stop button. Press once to start
cooking, press again to turn the product
off.
FIG. 2
230 V ~ 50 Hz
800 W
8 L
L37 x W25 x H22cm
USE
1. Fill the bath with water. The water level
should be between the MIN and MAX
marks. If the water bath is empty or the
water level is below the MIN mark, the
product will not start and will display error
code E04.
2. Ensure the power cable is properly
inserted in the power inlet on the rear of
the product and plug it into a suitable wall
socket. The display lights up.
3. Place the bags with vacuum-sealed food in
the bag rack and place it in the water bath.
– Never place food directly in the water
bath. Food must be bagged before it
is cooked.
– If a bag leaks or bursts during
cooking, remove the bag, empty and
clean the water bath, place the food
inside a new bag and recommence
cooking.
4. Setting the temperature and time with
the buttons on the display.
5. Press the start button. The product starts
and the icons for heating and water
circulation are displayed.
6. When the set time has been reached, the
product does not turn off. It continues
to operate for 1 hour. An audible beep is
produced every minute until the product is
turned off by pressing the Stop button.
7. When the set temperature has been
reached, the product stops heating and
the heating icon is no longer displayed. If
the temperature drops before the set time
has been reached, heating restarts and
the icon is displayed again.
8. If the temperature rises above 85°C, the
pump automatically shuts off and the
water stops circulating.
9. Empty the water bath after use. Allow the
water in the water bath to cool. Remove
the racks. Hold the handles and pour the
water out.
EN
19