Uline H-729 Fonctionnement

π
H-729
3M H180 2" PISTOL
®
GRIP DISPENSER
1. Place dispenser on flat surface. Push tape roll fully
onto tape wheel. Be sure tape unwinds with sticky
side down. (See Figure 1)
2. Unroll 5-6 inches of tape (sticky side down) and
thread between smoothing roller and metal loading
gate. (See Figure 2)
3. Pull tape over smoothing roller allowing tape to
unroll freely off tape wheel. (See Figure 3) To adjust
tension, see Figure 4.
4. Start desired depth on side of box. (See Figure 5)
5. Pull dispenser along the carton seam - smoothing
roller automatically presses tape to the package.
(See Figure 5)
Figure 1
PAGE 1 OF 3
1-800-295-5510
uline.com
OPERATION
Figure 2
Figure 5
6. Continue down the opposite end to desired length.
In one motion, tilt dispenser forward so tape pressing
wiper stops rolling tape, serrated blade cuts tape
and wiper smooths the tape end. (See Figure 5)
Pressing Wiper
Smoothing Roller
Cutting Blade
Adhesive Side of Tape Down
Metal Loading Gate
Figure 3
Start
Here
Para Español, vea página 2.
Pour le français, consulter les page 3.
Tension Knob
Figure 4
1020 IH-729