Worx WG650 Mode D'emploi page 15

2. gENEraL maiNtENaNcE tiPS
1) Do not attempt to repair the machine
unless you have the proper tools and
instructions for disassembly and repair of
the machine.
2) Check the shear bolts and other bolts at
frequent intervals for proper tightness
to ensure that the equipment is in safe
working condition.
3) After each snow removal session, run the
Snow Thrower for a few minutes to prevent
the Auger (7) from freezing. Shut off the
motor, wait for all revolving parts to stop
completely, and wipe residual ice and snow
off the unit. Rotate the Chute Crank Handle
(12) several times to remove any excess
snow.
3. rEPLaciNg thE rubbEr PLatES
(See Fig. w, X, y)
NotE: When replacing worn rubber plates,
pay close attention to carefully distinguish
between the coarse and smooth side of the
plates. Place the coarse side facing inside and
the smooth side facing outside.
1) Detach the worn rubber plate by removing
the two sets of nuts, bolts, and washers
used to secure it.
2) install the new rubber plate so that the
coarse side faces inward and the smooth
side faces outward.
3) After fitting the rubber plate (a) onto the
AUgeR (7) insert the bolt (d) through the
aligned holes, the bolt head should be
against the outer rubber surface. Make sure
to place a small flat washer (c) under the
bolt head, and a large flat washer under the
locknut (g). The locknut is used to secure
the bolt.
a: Rubber plate; b: Rivet; c: Small flat washer;
d: bolt; e: Auger; f: Large flat washer;
g: Locknut
4. rEPLaciNg thE ScraPEr
i: Scraper; ii: Screw; iii: Screwdriver
The scraper is located at the base of the Snow
Thrower beneath the rotor housing (See Fig. Z1).
1) Detach the worn scraper from the Snow
Thrower by removing the 3 screws that
hold it in place (See Fig. Z2).
Snow thrower
All manuals and user guides at all-guides.com
2) install the new scraper and fasten it
5. rEPLaciNg thE bELt
NotE: Determine the left and right hand sides
of the Snow Thrower by standing behind the
unit in the normal operating position.
1) Remove the screws from the left panel of
2) Lift the belt tension and roll the large belt
-big pulley; -belt tension;
-Large belt
3) Replace the large belt by following
StORAGe
1. Allow the motor to cool and clean
2. Disconnect the extension cord from the
3. inspect the extension cord closely for signs
4. inspect the Snow Thrower carefully for
5. Store the unit, along with the disconnected
securely to the Snow Thrower with 3
screws (See Fig. Z3).
the snowthrower.
off the big pulley (See Fig. AA).
instructions in reverse order.
the Snow Thrower before storing or
transporting. be sure to secure the unit
while transporting.
Snow Thrower.
of wear or damage. Replace it if it is worn
or damaged.
worn, loose, or damaged parts. Check
connections and screws and tighten if
necessary. For repairing or replacing parts,
contact your WORX dealer.
extension cord, in a locked, dry place
out of the reach of children to prevent
unauthorized use or damage. Cover loosely
with a tarp for added protection.
15
en