ALPENHEAT AJ27RC Manuel D'instructions page 6

EN
ENGLISH
ALPENHEAT Heated Socks FIRE-WOOLSOCKS
DE
Model: AJ27RC (set with 1 pair of socks) wool
CONTENTS
SK
- 1 pair of socks (AJ21) with integrated heating elements underneath the toes
- 2 battery packs (BP18) with LED lights and ON/OFF slide switch
PL - 1 battery charger (LG18) 100-240V 50/60Hz (mains plug)
- 1 USB charging cord with y-cables
- 1 Remote control (AC18)
SL
INSTRUCTIONS
HR
SAFETY INSTRUCTIONS
Keep the product out of the reach of small children, as it contains small parts which could be
SV swallowed. This product should not be used by individuals unable to determine when the
temperature is too hot or too cold. Small children are more sensitive to hot and cold. Certain
illnesses, e.g. diabetes, can cause impaired temperature sensitivity. Persons with disabilities or
LV
infirm persons might not be able to communicate that they are too warm or too cold. Therefore
the product is not suitable for children under the age of three, the infirm or individuals insensitive
to heat. If in doubt or if you have cardiovascular problems consult your doctor before using the
FR
product.
Only use the original recharger supplied with the product for charging the batteries. It has been
designed for indoor use only and should not be exposed to moisture.
Do not insert metal or other objects into the connection sockets or plug as this can damage the
product.
If you notice that the connection cables or any other parts are damaged, do not use the product.
Do not make any modifications to the product and do not use it for any purpose other than
intended.
If you feel any unpleasant sensation, such as tingling, that may be a sign that the heat setting is
set too high and should be reduced immediately or disconnect the sock from the battery pack.
If the product is not in use, the battery packs have to be disconnected from the socks.
Alpenheat products are not compatible with one another or with products from other
manufacturers, so never use chargers, heaters or battery packs from other products.
HOW TO CHARGE THE BATTERIES
The battery packs have be charged before each use. Batteries only reach their full capacity after
having been charged several times. To achieve the full capacity, proceed as follows:
1. Connect the charging cable with the adaptor.
2. Connect the charging cable with the 2 battery packs and push the plug into a houshold socked.
3. While charging the LED light on the battery packs will flash in red light.
4. When the battery pack is fully charged, the LED light on the battery pack will glow red.
5. Now you have the full power and you can use your heated socks.
Charge the batteries at an ambient temperature between 10° - 35° C / 50° - 95° F. The storage
temperature should not exceed 50° C / 122° F otherwise the batteries could be damaged.
4