Inventum staafmixer MX300 Mode D'emploi page 11

The TURBO button can also be used for instant power pulses
without having to set the speed.
Attention: do not activate the stick mixer constantly, this can
cause engine problems. Do not use the stick mixer for more
then one minute continuously, wait until the engine is cooled
down in three minutes before operating it again. Blend larger
quantities in multiples sessions.
The stick mixer can't exceed a running time of 15 seconds
without a load.
Always unplug the appliance from the supply if it is left
unattended and before assembling, disassembling and during
cleaning.
You can use the stick mixer in a bowl. When blending directly
in a saucepan while cooking, take the pan from the stove first
to protect the appliance from overheating.
MX300-instructions.indd 11
All manuals and user guides at all-guides.com
5
Always unplug the appliance from the supply if it is left
unattended and before assembling, disassembling and during
cleaning.
Disassemble the motor part from the accessory.
• Wipe the motor part and the connector with a damp cloth.
• Rinse the blender shaft with under a running tap.
• Do not use any abrasive or strong detergents. These can
• Never place the motor part, the power cable or the plug
cleaning & maintenance
damage the housing.
in water or any other liquid.
Be careful when cleaning the blender shaft by hand. The
knive of the blender shaft is extremely sharp.
11
English •
15-12-2014 12:24:13