RECOMMENDATIONS
The electrical installation of the part, the
installation of the device and its use must
comply with the regulations in force in your
country.
Do not use the device near flammable
objects and products, and, in general,
respect the minimum distance of 50 cm
between the device and other objects
(walls, curtains, mists, etc.).
The appliance must be placed so that the
electrical plug is accessible.
Do not pull on the power cord or the
appliance, even when you want to
disconnect the plug from the socket.
Never use the appliance leaning or lying on
its side.
This product is intended for domestic
use only. In the event of professional,
inappropriate use or use that does
not comply with the instructions, the
manufacturer declines all responsibility and
the guarantee will be void.
Fully unwind the cable before each use.
Do not use an extension cord not adapted
to the power of the appliance.
Do not switch on the appliance in a dusty
place or where there is a risk of fire.
DESCRIPTION
1. grate
2. Power & Mode rotary knob
3. Thermostat adjustment knob
4. Handle
5. Feet
OPERATION
The device can be operated using the
manual controls located on its side.
ATTENTION – The appliance must never be
put into operation without the feet being
properly fitted.
Feet assembly
Carefully remove the convector from the
box and bag.
The feet must be placed at the ends of the
lower part of the device.
Match the holes in the feet with the axles
located in the lower area.
Then screw them in (with the screws
provided).
Use
The appliance must be placed on a solid,
flat and stable surface.
Make sure the Power & Mode rotary knob
is in the off position (0) before plugging the
appliance into the wall outlet.
Plug the power plug into an electrical
outlet. Make sure the plug is securely in
the socket. If not properly seated, it can
overheat and damage the outlet. The cord
and plug assembly may become hot during
use. It is a normal situation and does not
interfere with the proper functioning of the
device.
Set the thermostat adjustment knob to the
MAX position.
Turn the Power & Mode rotary knob
to the desired temperature mode. Low
temperature (max. 1000W) is represented
by ( I ) and high temperature (max. 2000W)
by ( II ).
English
15