Publicité
Les langues disponibles
Les langues disponibles
Dispose a Frozen Washer dryer Machine
When the temperature drops below zero and your washer dryer
machine gets frozen, you may:
1. Disconnect the power supply for the machine.
2. Wash the tap with warm water to loosen inlet pipe.
3. Take down inlet pipe and immerse it in warm water.
4. Pour warm water into washing drum and wait for 10 minutes.
5. Reconnect inlet pipe to the tap and check whether inlet and
outlet are working normally. Notes: when the washing machine
is reused, make sure the ambient temperature is above 0'C
GB
Anti-freeze
If your machine is located in the room where it can get frozen
easily, please drain the remaining water inside drain pipe and
inlet pipe thoroughly.
Remove the remaining water in inlet pipe:
1. Close the tap.
2. Screw off the inlet pipe from tap and put its end into the
container.
3. Start up any procedure except single
Wash or Drain procedure. Water will be
drained out of inlet pipe if any for about 40
seconds.
4. Reconnect the inlet pipe to tap.
Remove the remaining water in drain pump
To avoid burning, it shall be done after the hot water inside the
machine cools down.
86
Clean detergent box and grooves
Clean detergent drawer and grooves
1. Press down the arrow location on softener
cover inside the drawer.
2. Lift the clip up and take out softener cover
and wash all grooves with water.
3. Restore the softener cover and push the drawer into position.
Clean inlet filter
Inlet filter shall must be cleaned if there is
not any or insufficient water in when the tap
is opened.
Clean the tap filter:
1. Close the tap.
2. Select any procedure except "Lavage"
(Wash) or "Rinçage et essorage" (Rinse &
Spin) procedure.
3. Press the button "Démarrage/pause" (Start/Pause) and keep the
procedure running for about 40 seconds.
4. Remove the inlet pipe from the tap.
5. Use water to wash the filter.
6. Reconnect the inlet pipe.
Washing the filter in washer dryer machine:
1. Screw off the inlet pipe from the backside
of the machine.
2. Pull out the filter with long nose pliers and
reinstall it back after being washed.
GB
87
Publicité
