JVC LT-43EC2502 Instructions page 6

. ,
LT-43EO叨2NC. User Manual ENG-FRA....090420 outlined.pdf6 9/4/2020 5>45:17 PM
®
t
....
10cm
髟
@ .. J · •
。
1.0pen the carton and remove the TV,accessories,and the feet.
2.To avoid damage to the TV,place on a table,face down on a
soft surface. T he feet are attached to the TV with provided
screws,or are attached by snapping into the cabinet till you
hear the click.
3.Ensure the feet are tightened/snapped-in securely. Do not
overtighten.
®
®
All manuals and user guides at all-guides.com
Install and Connect TV
10cm
｀
。
TV Feet Installation Instructions
Setup your TV
1 .Put your TV in a place that can support the
weight of the TV.
To avoid danger, please do not assemble
the TV near water or extreme heat(such
as a furnace, light source,or candle.)
�
Do not block the ventilation on the back
10cm
of the TV.
Connect signal source and power
2 . Connect the antenna cable to the RF
connection on the back or side of the TV,
and/or the signal source HDMI cable to the
HDMI input(s) on the rear or side ofTV. Plug
the TV into the wall power outlet (AC100-240V-
50 /60Hz).
Turn on the TV
3.Connect the power supply,
enter the standby mode (red light),
press the power button of the TV or
the power button on the remote control
to turn on the TV.
Note:
Picture for reference purposes only.
Please take note of the base direction:
The bottom view of the TV
(Front cabinet faces down)
(The illustration is for reference only, Please prevail in kind)
04
® |
®
®
＿ ®