Fein Turbo I Mode D'emploi page 9

All manuals and user guides at all-guides.com
3 41 01 116 06 0.book Seite 9 Freitag, 17. Dezember 2010 12:42 12
Mounting/dismounting the vacuum
hose (Figure 6).
Turbo I, Turbo II:
Insert the vacuum hose to the stop in
the hose connection socket until tightly
seated.
To remove the vacuum hose, press the
release button and pull the vacuum hose
out.
Turbo III:
Insert the vacuum hose into the hose
connection socket until tightly seated.
To remove the vacuum hose, hold
hose close to the vacuum body and twist
hose while pulling.
Working instructions.
Before mounting or replacing accessories, pull the plug. This preventive safety
WARNING
measure rules out the danger of injuries through accidental starting of the vac-
uum cleaner.
The motor of the vacuum cleaner is equipped
with a soft-start function.
The vacuum cleaner starts with the last set
suction capacity.
Switching on and off without a power
tool connected (Figure 7).
First check that the power
WARNING
cord and power plug are not
damaged.
:
Switching ON
Set the On/Off switch to ( II ).
:
Switching OFF
Set the On/Off switch to ( O ).
Mount accessories applying only slight
pressure. For disassembling, turn the
parts somewhat against each other and
pull apart.
Fig. 6
Hose
connection
socket
Vacuum hose
Fig. 7
On/Off switch
en
9