Fein Turbo I Mode D'emploi page 11

All manuals and user guides at all-guides.com
3 41 01 116 06 0.book Seite 11 Freitag, 17. Dezember 2010 12:42 12
Vacuuming fluids.
Before vacuuming fluids, always remove
the paper-dust bag or the textile perma-
nent filter, and check the operation of the
float.
When wet vacuuming, the air flow is inter-
rupted by means of a float after reaching the
maximum filling height. Switch off the vac-
uum cleaner immediately, pull the plug from
the socket outlet and empty the container.
When foam or water comes out, switch off
the vacuum cleaner immediately and empty
the container.
Emptying the container on the Turbo I:
Switch the vacuum cleaner off.
Open the fasteners on both sides and
take off the vacuum cleaner lid.
Empty the container.
Vacuuming dry materials.
For dry vacuuming, insert the filter cartridge
in the vacuum cleaner.
For dry vacuuming, additionally use the paper
or the textile dust bag.
Empty the container each time after using and
remove coarse debris and dust.
Emptying the container on the Turbo II and
Turbo III (Figure 10):
Switch the vacuum cleaner off.
Empty the container after vacuuming fluids.
Afterwards, run the vacuum cleaner with the
accessories connected for several minutes in
order to dry them.
Pull off the protective cap.
Pull the lever toward the front to open
the valve in order to drain the dirty
water.
After draining the dirty water, push
the lever toward the rear again in order
to shut the valve, and reattach the pro-
tective cap.
Fig. 10
Lever
en
11
Protective cap