Publicité
Oven Initial Start-up Checklist - Remove & Return to XLT Ovens
2nd step
:
Place all control boxes in service position and document settings, remove blue tag from
inside control box and connect switch to wire harness. Start each oven and complete form below.
Top Oven
Model #: __________________________________
Serial #: __________________________________
Front Belt Speed: _______min ______sec
Back Belt Speed: _______min ______sec
Electrical Supply (per oven):
Volts
Middle Oven
Model #: __________________________________
Serial #: __________________________________
Front Belt Speed: _______min ______sec
Back Belt Speed: _______min ______sec
Electrical Supply (per oven):
Volts
Bottom Oven
Model #: __________________________________
Serial #: __________________________________
Front Belt Speed: _______min ______sec
Back Belt Speed: _______min ______sec
Electrical Supply (per oven):
Volts
Customer Signature:
NOTE:
Take off front panel and remove finger clips (holds fingers in place during transportation).
Check for proper installation and placement of return air/end loss plates (step 6, page 36).
N/A
Proper Belt Tension:
Conveyor Belt Direction:
Set Point Temp: Left ________ Right _________
Fingers in proper location:
N/A
Fire Suppression Installed:
Amps
N/A
Proper Belt Tension:
Conveyor Belt Direction:
Set Point Temp: Left ________ Right _________
Fingers in proper location:
N/A
Fire Suppression Installed:
Amps
N/A
Proper Belt Tension:
Conveyor Belt Direction:
Set Point Temp: Left ________ Right _________
Fingers in proper location:
N/A
Fire Suppression Installed:
Amps
L to R
Hz
L to R
Hz
L to R
Hz
Date:
Yes
No
R to L
Yes
No
Yes
No
Phase
Yes
No
R to L
Yes
No
Yes
No
Phase
Yes
No
R to L
Yes
No
Yes
No
Phase
Publicité
