Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
DIGITAL TUNER
MW (AM) TUNING STEP (SOME VERSIONS ONLY)
In North and South America the frequency step between adjacent
channels in the AM band is 10 KHz. In the rest of the world this
step is 9 KHz. Usually this frequency step has been preset in the
factory of your area.
To change the tuning step
1. Adjust the CD TUNER TAPE/
2. Press and hold down on BAND and SEARCH ∞ simultaneously
to select 9 KHz.
3. Adjust the CD TUNER TAPE/
then release the BAND and SEARCH ∞ controls.
™ All preset stations will be lost and need to be programmed
again.
• To select 10 KHz, repeat steps 1-3 but use SEARCH §
instead.
TUNING TO RADIO STATIONS
1. Adjust the CD TUNER TAPE/
2. Press BAND to select your wave band.
To tune to radio stations, press the SEARCH or TUNING
controls ∞ or § until the frequency in the display starts
running, then release the control.
™ Srch appears in the display and the radio automatically
tunes to a station of sufficient reception.
3. Repeat if necessary until you find the desired station.
• To tune to a weak transmitter, briefly press SEARCH ∞ or
§ until you have found optimum reception or the correct
frequency.
™ When
appears in the display, you are receiving a FM-
STEREO
stereo transmitter.
To improve radio reception
• For FM, pull out the telescopic antenna. Incline and turn the
antenna. Reduce its length if the signal is too strong (very
close to a transmitter).
• For AM, the set is provided with a built-in antenna so the
telescopic antenna is not needed. Direct the antenna by
turning the whole set.
10
slider to TAPE/
position.
OFF
OFF
slider to TUNER position and
OFF
slider to TUNER position.
OFF
TUNER
TUNER
FM
Publicité
