Wichtige Sicherheitsinformationen - Philips Senseo HD7806 Mode D'emploi

Problem Possible cause
My coffee cup You did not flush the
overflows with machine before first
cold coffee use.
The indicator light The machine is
flashes slowly. heating up.
The indicator light There is not enough
flashes quickly. water in the water
reservoir
The float in the water
reservoir may be
stuck.
The coffee is not You need to descale
hot enough. the machine.
The coffee Do not use cups that
temperature in are too large.
the cup decreases
quickly.
Intensity select: You have pressed
after pressing the coffee button
the coffee button twice too fast or you
twice, I do not get have waited longer
a stronger coffee. than 3 seconds after
pressing the button
for the first time.
I cannot open A temporary vacuum
the lid. has developed under
the lid.
The coffee Perhaps the sieve in
machine produces the center of the pod
less coffee than holder is clogged.
before.
Perhaps you have
pressed the 1 or
2-cup button twice.
I cannot close the Perhaps a used
lid properly. coffee pod is
sticking to the water
distribution disk.
The coffee is not You may not have
strong enough. used the right number
of pods or may have
pressed the wrong
button.
The pod(s) may not
have been placed
in the pod holder
properly.
You may have used
the same pod twice.
Perhaps you need a
different flavor.
HD6554, HD6555,
HD6556: Use
intensity select.
The coffee is too Perhaps you need a
strong. different flavor.
Perhaps you pressed
the 1-cup or 2-cup
button twice.
Water leaks You have not closed
from the coffee the lid properly.
machine.
You have not placed
the pod(s) in the
holder correctly.
You overfilled the
water reservoir.
The sieve in the
center of the pod
holder may be
clogged.
Solution
Always flush the machine before
first use.
If this takes longer than 2 minutes,
contact the Philips Consumer Care
Center in your country
Fill the water reservoir and make
sure you place the water reservoir
properly into the machine.
Empty the water reservoir and shake
it a few times to release the float.
Clean the water reservoir with hot
water and some washing-up liquid or
in the dishwasher.
Descale the machine according to
the instructions.
Use thin-walled cups.
Thin-walled cups absorb
less heat from the coffee than
thick-walled cups.
You can preheat the coffee machine
and cup by brewing a cup of hot
water first without placing a coffee
pod in the pod holder.
Pressing the coffee button twice
to get a stronger coffee is possible
within a time frame of 3 seconds.
The LED light on the machine will
shine less bright if the programming
was successful.
Switch off the coffee machine. Pull
up the lever and wait
24 hours before you open the lid.
You may need to use some force.
Always make sure the pod holders
are clean and the sieve is not
clogged to prevent a vacuum.
If the sieve is clogged, use a
washing-up brush to unclog
the sieve. If you cannot unclog
it properly with the washing-up
brush, put the pod holder in the
machine and descale the machine
according to the instructions.
This machine has Intensity Select. If
you press the button twice, you get
a smaller cup of stronger coffee.
If this is the case, remove the used
pod.
Use 1 pod in combination with the
1-cup pod holder and the 1-cup
button. Use 2 pods in combination
with the 2-cup pod holder and the
2-cup button.
Place the coffee pod(s) properly
in the center of the pod holder, to
prevent water from escaping along
the edge of the pod(s). When you use
two coffee pods on top of each other,
make sure that the convex sides of
both pods point downwards and
press the pods lightly into the pod
holder. Make sure that the coffee in
the pod is distributed evenly.
Place a new pod in the pod holder to
brew a fresh cup of coffee.
If you prefer a more robust flavor,
SENSEO® coffee pods with a
stronger blend are available.
Press the button twice to brew
one or two small cups of stronger
coffee.
If you prefer a milder flavor,
SENSEO® coffee pods with a milder
blend are available.
This machine has Intensity Select. If
you press the button twice, you get
a smaller cup of stronger coffee.
Close the lid properly and lock the
lever.
Place the pod(s) properly in the
center of the pod holder with the
convex side pointing downwards,
as shown in the instructions.
Do not fill the water reservoir
beyond the MAX level.
Check the pod holder. If the sieve is
clogged, use a washing-up brush to
unclog the sieve. If you cannot clean
it properly with the washing-up brush,
put the pod holder in the machine
and descale the machine according to
the instructions.
The sealing ring
may be stuck under
the edge of the
distribution disk.
Water drops on the
worktop may be
the result of placing
the water reservoir
or removing used
coffee pods.
The machine has
been stored in a
room that was not
frost-free.
The appliance
switches off
automatically after
5 minutes.
Flush before first use
Flush the machine before first use. After the flushing cycle (which only takes
approx. 2 minutes), the machine is ready for brewing coffee.
Intensity Select (HD6556, HD6555, HD6554)
It is possible to brew even shorter stronger cups of coffee by double pressing the
1-cup or 2-cup button.
Special coffees
To brew a special coffee, place a cappuccino pod, a hot chocolate pod or
another special coffee pod in the 2-cup pod holder and press the 1-cup button.
2x descaling, 2x rinsing
Descale the machine at least every 3 months. Use liquid SENSEO® descaler only. The
descaling procedure consists of two descaling cycles and two flushing cycles. Each
cycle lasts 5 minutes. Fill a jug with 1 liter of water, pour one half of the bottle in the jug
and then pour the descaling mixture in the water reservoir. Press the 2-cup button
several times until all descaling mixture is used up. You have to use 1 jug of descaling
mixture for each descaling cycle. Use the 1-cup pod holder with a used pod or the
thin descaling filter during the first descaling cycle and use the 2-cup pod holder with
a used pod or the thick descaling filter during the second descaling cycle. Fill the
water reservoir with fresh water and press the 2-cup button several times until the
water reservoir is empty. Repeat this for the second flushing cycle. Do not interrupt
the descaling cycles and do not switch off the machine before you have performed
the two flushing cycles. Throw used pods or descaling filters away after use. For more
information on why it is important to descale, when to descale and how to descale or
which descaler to use, visit our website at www.philips.com/descale-senseo.
Automatic shut-off.
The appliance switches off automatically after 30 minutes. Appliances with this
logo , switch off automatically after 5 minutes of inactivity to save energy.
Deutsch
Einführung
Herzlichen Glückwunsch zu Ihrem Kauf und willkommen bei Philips! Um die
Unterstützung von Philips optimal nutzen zu können, sollten Sie Ihr Produkt unter
www.philips.com/welcome registrieren. Diese neue SENSEO® Kaffeemaschine
(HD6554, HD6555, HD6556) bietet Ihnen eine größere Vielfalt dank Intensitätsauswahl.
Neben dem langen, weichen SENSEO® Kaffee können Sie einen starken, kleineren
SENSEO® Kaffee zubereiten, indem Sie die Taste einfach zweimal drücken.
Sauberes kaltes Wasser
Verwenden Sie täglich sauberes kaltes Wasser. War die Maschine über 1 Tag nicht
in Gebrauch, lassen Sie vor dem nächsten Aufbrühen sauberes kaltes Wasser
durchlaufen. Um die Maschine durchzuspülen, füllen Sie den Wassertank mit
sauberem kaltem Wasser, stellen Sie eine Schüssel oder zwei Tassen unter den
Auslauf, und drücken Sie mehrmals die 2-Tassen- Taste, damit heißes Wasser
durchläuft, bis der Wassertank leer ist.
Frische Kaffeepads
Verwenden Sie die speziell für Ihre SENSEO® Kaffeemaschine entwickelten
SENSEO® Kaffeepads für ein weiches, volles Aroma. SENSEO®-Kaffeepads bleiben
länger frisch, wenn Sie sie in einem verschließbaren Behälter aufbewahren.
Ein sauberes Gerät
Reinigen und entkalken Sie die Philips SENSEO® Kaffeemaschine alle 3 Monate.
Weitere Informationen über die Wichtigkeit des Entkalkens, Anweisungen
zum Entkalken oder den richtigen Entkalker finden Sie auf unserer Website
www.philips.com/descale-senseo.

Wichtige Sicherheitsinformationen

Lesen Sie diese Bedienungsanleitung vor dem Gebrauch der Maschine
aufmerksam durch, und bewahren Sie sie für eine spätere Verwendung auf.
Check if the sealing ring is stuck
under the edge of the distribution
disk. If it is, pull it out from under the
distribution disk carefully.
Check if the water drops on the
worktop are not the result of placing
or removing the water reservoir or
removing used coffee pods. Make
sure that you do not remove the water
reservoir when the coffee machine
is heating up. This may cause water
that normally ends up in the water
reservoir to leak out of the machine.
In all other cases, contact the
Philips Consumer Care Center
in your country.
Contact the Philips Consumer Care.
Center in your country.
Appliances with this logo ,
switch off automatically after 5
minutes of inactivity to save energy.