VITO Pro Power VILGE710 Mode D'emploi page 30

Avoid pressing the "ON/OFF" switch when lifting or carrying
the power tool and it is plugged in. There may be contact
with the sanding disc and clothing may get jammed.
Control and safety devices fitted to the power tool may not
be removed or inhibited.
If the sander allows dust extraction devices to be fitted,
ensure these are properly attached and used correctly. The
use of vacuum cleaners reduces dust and associated
hazards.
Do not cover the power tool during operation. To avoid risk
of overheating, keep
unobstructed to allow airflow.
When operating the drywall sander, adopt a stable position
and always keep your balance. Hold the power tool firmly
to ensure continuous operation and withstand unexpected
situations, such as kickback.
Kickback is a sudden reaction that happens when the
sander is switched on and when the sanding disc gets stuck
or is squeezed. The kickback causes the rotating part to
stop instantly, which causes the sander arm to be forced to
rotate in the opposite direction to the rotation of the
sanding disc.
Kickback occurs due to incorrect use of the sander or work
procedures that are not appropriate for the work being
performed and can cause serious injury to the user. To
avoid kickback, the following precautions must be
considered:
▪ Place and keep the sanding disc in the correct position
and tighten securely;
▪ Never place your hand near the rotating part, it may may
recoil on your hand;
▪ Always use the additional handle to achieve maximum
control of kickback forces or reaction torques during
acceleration;
▪ Do not position your body in the area where the sander
arm will move in the event of a kickback;
▪ Work particularly carefully on corners, sharp edges or
gaps in the walls and ceilings to be sanded. Avoid
bumping the Velcro pad during work. Do not use the
sander if the walls or ceilings have a very uneven surface.
ventilation slots clean
When operating the machine, plan pauses and avoid
operating it for long periods of time. Permanent vibrations
are harmful to health.
Operating the power tool causes high load of vibrations
which can cause damage to the circulatory and nervous
systems, especially in people with circulatory problems.
Seek medical attention if symptoms occur that may be
caused by vibrations. These symptoms, which occur mainly
in the fingers, hands or wrists, include, for example, loss of
sensation, pain, muscle weakness, discoloration of the skin
or unpleasant tingling.
and
Avoid using the power tool on wood coated with paint
containing lead or other materials that are harmful to
health. Any contact or inhalation of dust may cause allergic
reactions and/or breathing disorders. Wear a mask and use
a vacuum cleaner if possible.
Materials containing asbestos may not be worked. Asbestos
is carcinogenic.
Before performing
accessories, repairing and maintenance tasks, you must
unplug the power cord.
Replace worn out or damaged parts immediately, so that
the power tool is always in a safe operating condition.
Cleaning:
The power tool should be thoroughly cleaned thoroughly
after each use.
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the power tool.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out, all other works must be
performed by an official dealer.
cleaning, adjusting, changing