NEFF C1 KS61N0 Série Mode D'emploi page 57

Masquer les pouces Voir aussi pour C1 KS61N0 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

en
Important: Before starting each
F
service program (Descale, Clean or
calc'nClean) remove the brewing unit,
clean as instructed and replace it�
Be careful not to jam the milk tube
when closing the door�
After completion of each service
programme, wipe the appliance
immediately with a soft, damp cloth
to remove any residues from the
descaling and cleaning solution� It is
possible for corrosion to form under-
neath such deposits�
New sponge cloths may contain
salts� Salts can cause rust film on
stainless steel and must therefore be
washed out thoroughly before use�
Clean the beverage outlet, milk tubes
and connecting piece thoroughly�
Specially developed, suitable
F
descaling and cleaning tablets are
available from retail outlets or from
customer services (see the section
"Accessories")�
Descaling
Takes about 21 minutes�
● Touch E�
● Select "Descale" with the K or L
arrow button�
● Touch C� The display indicates the
progress of the programme�
● Empty the drip trays and replace�
● Remove the water filter (if there is one)
and press C�
● Pour lukewarm water into the empty
water tank up to the "0�5 l" mark and
then dissolve one Neff descaling tablet
00576693 in it� For the 00310967 you
should always dissolve two tablets�
Neff
If there is not enough descaling
F
solution in the water tank, you will be
asked to do the following� Refill using
uncarbonated water and press C
again�
● Remove the milk tube from the milk
container and fix the connecting part to
the right side of the beverage outlet with
the magnet�
● Close the appliance door�
● Place a container with a capacity of
0�5 litre under the beverage outlet�
● Put the end of the milk tube into the
container�
● Touch C� The descaling programme
will now run for about 19 minutes�
● Remove the container and touch C�
● Rinse the water tank and (if removed)
replace the water filter.
● Fill the tank with fresh water up to the
"max" indicator�
● Replace the water tank and close the
door�
● Place the container underneath the
beverage outlet again�
● Put the end of the milk tube into the
container�
● Touch C� The descaling programme
will now run for about 2 minutes and rinse
the appliance�
● Remove the container, empty the drip
trays, replace and close the appliance
door�
● Touch C� The appliance has finished
descaling and is ready for use again�
● Touch E to exit the programme�
53
C1.KS61N0 | 07/2014

Publicité

Table des Matières
loading

Table des Matières