WeatherTech No-Drill MudFlaps Instructions D'installation

No-Drill MudFlaps
1
Start by thoroughly washing your vehicle. Take
care to remove all dirt, debris, and stains from
each fender in the areas corresponding to
where the MudFlaps will be installed.
2
Park the vehicle on level ground with the
wheels turned fully to the left. Begin with the
driver's side MudFlap installation.
3 3
Locate the (2) two factory plastic fasteners at the
inner fender as indicated.
5 5
Pull the inner fender liner out to reveal the areas
where supplied hardware will be installed. Take (2)
two supplied U-clips and install them over each metal
tab as indicated. Make sure the hole in each U-Clip is
lined up with the factory hole it is installed over.
Installation Instructions
4 4
Using a trim clip remover, remove the (2) two factory
plastic fasteners at the inner fender. Pull the head
up and the base out of the fender. They will not be
reused.
6 6
Put the inner fender liner back into place. Then,
using the MudFlap marked "LH," place it up to the
fender and align with the corresponding holes.
What You Need
Ratchet and Socket Set*
Trim Clip Remover*
*Not included
48MF573 Parts Kit x 2:
(4) Hex Head Screws
(4) U-Clips