Ninja BL660C Manuel Du Propriétaire page 13

Use of the Nutri Ninja
WARNING: Handle the Nutri Ninja Blade Assembly with care, as the blades are sharp.
WARNING: Never leave the appliance unattended while in use.
WARNING: Remove utensils prior to processing. Failure to remove may cause the Nutri Ninja cup to be
damaged or to shatter, which may cause personal injury.
CAUTION: Do not blend hot liquids, doing so may cause excessive pressure buildup, resulting in risk of the
user being burned.
CAUTION: Remove the Nutri Ninja Blade Assembly from the cup upon completion of blending. Do not store
ingredients before or after blending in the Nutri Ninja cup with the blade assembly attached. Some foods
may contain active ingredients or release gases which will expand if left in a sealed container, resulting in
excessive pressure buildup that can pose a risk of injury. For ingredient storage in the cup, only use To-Go
Lid to cover.
IMPORTANT: Make sure that the motor base is plugged in for use.
ASSEMBLY
Fig. 1 Fig. 2
1 Review warning and caution statements above before
proceeding to number 2.
2 Place the motor base on a clean, dry, level surface such
as a counter or table top.
3
Add ingredients to the Nutri Ninja cup.
NOTE: Do not overfill! To avoid spilling, do not add
ingredients past the "Max" fill line.
NOTE: Do not blend ice cubes without adding a liquid
or the product may overheat.
4
Place the Nutri Ninja Blade Assembly onto the cup and
screw it tightly until you have a good seal. (Fig. 1)
5 Turn the Nutri Ninja cup upside down and place it
onto the motor base, aligning the tabs on the cup with
the motor base. Turn the Nutri Ninja cup clockwise to
lock into place. You will hear a click when the lock is
engaged. (Fig. 2)
6 Press down on the Single Serve button in short
intervals to activate. (Fig. 3)
Cup
™
USE
Fig. 3
For best results, use short "PULSES"... Practice makes perfect!!
Fig. 4
7
When you have reached your desired consistency, stop
the appliance by removing your hand from the Single
Serve button.
8 To remove the Nutri Ninja Cup, ensure that the motor
has stopped running. Then turn it counter-clockwise
(Fig. 4) and pull straight up to remove. (Fig. 5)
9 Turn the cup upright and remove the Nutri Ninja Blade
Assembly by twisting the blade assembly counter-
clockwise. (Fig. 6)
10 Do not store blended contents with the Nutri Ninja
Blade Assembly attached.
11 Place the To-Go lid onto the Nutri Ninja cup, twist to
seal and enjoy!
12 For storage, only use the To-Go lid to cover.
13 Be sure to store the Nutri Ninja Blade Assembly
attached to an empty cup when not in use.
14 Make sure that the motor base is unplugged when not
in use.
REMOVAL
Fig. 5 Fig. 6
ninjakitchen.com
EN
12