Télécharger Imprimer la page

Robern V14 Serie Installation page 9

Publicité

FRAME INSTALLATION
INSTALLATION DU CADRE
INSTALACIÓN DEL MARCO
4. Level the frame and tighten to the wall as
shown on page 8 and here in Figure 4. The
left keyhole is elongated to allow for up and
down adjustment.
5. Install the 4 Structural Screws (203-1256)
into the 4 top frame holes. Figure 5. A T-30
Torx Bit is provided. If the wall is bowed,
shim where required.
6. As shown in Figure 6, shim the bottom at
the frame/side intersection.
7. Install 2 #10 x 2" (SS674) through the
narrow slot of the keyhole on the flange as
shown in Figure 7.
4
5
Shim
Cale/ Calza
rev. 07/16/14 © 2014 Robern, Inc.
All manuals and user guides at all-guides.com
4. Mettez le cadre au niveau et fixez-le au mur comme le
montre l'illustration de la page 8 et ici dans le graphique 4.
L'orifice de gauche est allongé pour permettre des réglages
de haut en bas
5. Installez les 4 vis de structure (203-1256)
Dans les 4 trous supérieurs du cadre. Graphique 5. Un
embout Torx T-30 est fourni. Si le mur est voûté, placez des
cales au besoin
6. Comme le montre le graphique 6, placez une cale au
fond du cadre/intersection de côté.
7. Installez 2 #10 x 2 po (50 mm) (SS674) à travers la
fente mince de l'orifice sur le rebord comme le montre le
graphique 7.
6
7
[203-1256]
5/16" x 2 1/2"
4-Structural Bolt
4-Boulon
4-Perno estructural
800.877.2376
www.robern.com
4. Nivele el marco y ajuste a la pared como se
muestra en la página 8 y aquí en la Figura 4.
El orificio izquierdo está alargado para permitir el hacia
arriba o abajo.
5. Instale los 4 tornillos estructurales (203-1256) en los 4
orificios superiores del marco. Figura 5. Se proporciona
una punta de destornillador estrella (Torx) T-30. Si la
pared está arqueada, coloque tacos donde sea necesario.
6. Como se muestra en la Figura 6, calce la parte inferior
en la intersección del marco/costado.
7. Instale 2 de los #10 x 2" (SS674) a través del
de la ranura del orificio en el reborde como
se muestra en la Figura 7.
Shim
Cale/ Calza
209-1157 V14 SERIES
SS674
#10 - 2"
9
SERIE DE V14 / SÉRIES V14

Publicité

loading