Publicité
MOUNTING, CONTINUED:
3) (ACCESSORY LATC OPTION) – BEFORE INSTALLING IN CEILING
a. Using hand tools only (NO POWER TOOLS), remove the two screws holding each of the T-Grid clips to the fixture frame.
(All four locations on fixture)
b. Remove the T-Grid clip and replace with the LATC adapter. See Figure 11.
c. Using the two screws removed in Step a., hand tighten screws to secure LATC adapter to fixture frame. Taking care not to
strip threads.
d. Once fixture is in T-Grid, attach LATC clips to LATC Adapter using screws provided. (Use LATC clips at all 4 locations).
See Figure 12.
FIG. 11: SWAPPING T-GRIP CLIP FOR LATC ADAPTER
CONTROLS / OPTIONS:
1) TUNABLE WHITE (TUWH) NLIGHT CONTROLS
a. Make connections between fixtures, and to control devices, using CAT5e cables. Connection point on fixture is located on
the back of the fixture at the controls enclosure. See Figure 13.
b. For fixtures with integrated sensors, the control device will be inside the controls enclosure and a splitter adapter will be
presented outside of the enclosure.
NOTE: nLight bus power is not provided from the fixture with Tunable White controls. In order to work, these fixtures require
additional components
nLight information please see
CAT5e connection
point
FIG. 13: TUWH CONTROLS CONNECTION
www.lithonia.com I 800-705-SERV (7378) I
We reserve the right to change design, materials and finish in any way that will not alter installed appearance or reduce function and performance.
LATC Adapter
(nLight® TUWH Programming
(nLight® Wired Networked Lighting Controls
TechSupport-CommercialIndoor@AcuityBrands.com
CPXTW LED INSTALLATION INSTRUCTIONS
LATC clip
mounting holes
FIG. 12: ATTACHING LATC CLIPS TO T-GRID
Guide), such as an nPS 80 Bus Power Supply (not provided). For general
Platform).
I © 2023 Acuity Brands Lighting, Inc. All Rights Reserved.
Hanger wire
attach point
LATC Clip
T-Grid
6 of 7
Publicité
