Publicité
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the
product.
WARNING
• Follow these installation instructions carefully. Proper installation is the installer's responsibility.
• Failure to follow correct installation procedures can cause the faucet to become loose, which can
result in serious injury.
• The product should be installed by a locally licensed plumber.
• When installing the flexible hose, please note there should be no torsion or deformation. Do not
fold it into a V or L shape, and do not use it if there are any cracks or damage.
• This product is engineered to meet the EPA Watersense flow requirements. The flow rate is
governed by the aerator. If replacement is ever required, be sure to request a Watersense compliant
lavatory faucet aerator to retain the water conserving qualities of this product. The max flow rate of
this product is 1.5 GPM (5.7 LPM) at 60 PSI.
Note: Please DO NOT use plumber's putty on plastic components. Use silicone caulk if sealant is
required.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 12 minutes
Tools Required for Assembly (not included): Adjustable wrench, faucet wrench, Phillips screwdriver,
silicone tape.
Helpful Tools (not included): Pliers, safety goggles.
• Prior to beginning installation, turn off the cold and hot water lines and turn on the old faucet to re-
lease built-up pressure.
• When installing your new faucet, first hand-tighten connector nuts. Then use one wrench to hold the
fitting and a second wrench to tighten the nut an additional 1/4 turn. Connections that are too tight
will reduce the integrity of the system.
All manuals and user guides at all-guides.com
3
Publicité
