NEXT BASE Click&Go Lite Serie Manuel D'instructions page 14

TROUBLESHOOTING
Symptoms
No power
No image on second
screen
Unable to play the
disc
Unable to play the
USB files
No display
No sound
Remote control
doesn't work
Display has lines
upon
Unable to charge the
player
Note: Clean and maintain the product only as recommended earlier in this instruction manual.
12
All manuals and user guides at all-guides.com
Possible causes
Check that the red LED light illuminates
on the cigarette plug.
Check that the stanchion mount is
connected correctly, as there is no
internal battery in the player.
Check that the stanchion mount is
connected correctly, with the Cable Yo
Yo is in place. This cable is required for
image and sound display on the second
screen.
Disc is not loaded correctly.
Disc is scratched or not clean.
Wrong regional disc.
Incompatible file format or USB has errors
upon.
AV cable is disconnected.
Wrong setting or connection to the player. Check settings and connections are all correct.
Wrong input mode setting.
Volume set too low.
Wrong setting or connection to the player. Check settings and connections are all correct.
Battery exhausted.
Any diagonal lines indicate that the
screen has been smashed.
This is normal as there is no internal
battery in the Click Lite DVD player or
monitor.
Remedies
If no LED is lit, check the fuses within the body
of the cigarette plug by removing the tip. Fuse is
within. Replace a blown fuse, with same rating.
Clean the contacts on the rear of the screen(s)
and also the mount. Use a cotton bud and
alcohol based fluid to clean the contacts.
Clean the contacts on the rear of the screen(s)
and also the mount. Use a cotton bud and
alcohol based fluid to clean the contacts.
Load the disc with the label side up and firmly
press it on to the rotating spindle.
Make sure there is no scratch or fingerprint on it.
Use the right regional disc.
Re-format the USB with FAT32 and verify
media files are correct type as described in this
manual.
Connect the cable firmly.
Set the input mode correctly.
Turn the volume wheel on DVD player and / or
monitor up.
Replace the battery.
Contact your NEXTBASE repair agent for
details of the LCD panel replacement cost.
Connect the car power, mains power or an
external battery (optional) to operate the player.