Publicité
Step 7
Separate the EXTENSION SLIDES (U) from the EXTENSION RAILS (T) as shown in the upper diagram
å
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (T) to the ENDS (A and B). Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide
å
the inner cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END.
Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWER.
å
Push the black lever in and pull the SLIDE from the RAIL.
Open end
T
www.sauder.com/services
U
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
B
P
3S
Open end
T
A
419960
T
H
Page 11
Publicité
