Publicité
Les langues disponibles
Les langues disponibles
PRE-lOAdInG A nEw ROll
1.
Remove the stub roll from the Roll support Arms (5)
and place in the stub Roll tray (9) at the bottom of
the dispenser.
2. Place a new roll on the Roll support Arms (5) with the
paper unwinding from the back.
3. Place the end of the paper under the transfer Clips
(10).
4. when the stub roll is exhausted, a user can start the
pre-loaded roll by turning the Knob (2) two full turns.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 2 OF 4
iNsTruCTiONs CONTiNuEd
ClEAnInG
lOCK And KEy
1-800-295-5510
uline.com
• EXtERIOR: Avoid using abrasives and solvents which
will damage plastic.
• IntERIOR: the dispensing Module (1) may be
removed from the housing to facilitate cleaning.
depress the two Module Retaining tabs (3) and lift
up. when reinstalling, be careful to align the bottom
ribs on the Module with the slots on the back of the
housing, before sliding into place.
• the standard lock with a removable standard Key (7)
is provided for security.
• If you do not require a keyed lock, a snap-in Key (6)
is provided. the snap-in key is installed by pushing
it down firmly into the lock and rocking it slightly until
it snaps.
0514 IH-2273
Publicité
