Specifications; Assembly Instructions - Active MS 8400 Manuel D'utilisation

11. Always be sure of your footing; keep a firm hold of the blower pipes, and walk, never run while operating a power blower.
12. Use the correct accessories. Do not use the power blower for any job except that for which it is intended .
13. Keep all fasteners tight and be sure the power blower is in safe working condition. Follow the maintenance instructions provided on page 10 - 12 of this
manual.
14. Do not put hands or feet near or under the rotating parts. Keep clear at all times.
15. If the power blower should start to vibrate abnormally, stop the engine immediately and check for the cause. Vibration is generally a warning of trouble.
16. Avoid using the power blower near rocks, gravel, stones and similar matter in order to avoid dangerous flying debris.
17. Use the power blower only in daylight or good artificial light.
18. Do not allow bystanders in work area.
19. Do not operate without guard(s) in place.
20. Do not operate in unventilated area.
21. To reduce the risk of injury associated with the inhalation of dust, use a face filter mask in dusty conditions.
22. To reduce the risk of injury associated with contacting rotating part, stop the engine before installing or removing attachments.
23. To reduce the risk of fire and burn injury:
-Move at least 10ft (3m) away from the fueling point before starting engine.
-Always store gasoline in approved container.
Models
Dimensions L x W x H
Dry Weight
Engine Type
Displacement
Ignition System
Carburetor
Fuel Tank Capacity
Fuel Mixture:
2-cycle engine oil designed for use in
air-cooled, high performance 2-cycle engines.
Attachments (Standard)
Assembly and attachment of the throttle lever bracket and blower pipes are required.
Main nameplate:
L
108
WA
dB
STEP #1) Locate and identify all the components (see sketch).
CLAMP
FLEXIBLE
PIPE
STEP #2) Using the BANDS, connect the FLEXIBLE PIPE to the blower, and the SWIVEL PIPE to the flexible pipe (see sketch).
STEP #3) Assemble the STRAIGHT PIPE, END PIPE, and FAN-BLOW HEAD, then connect them to the swivel pipe (see sketch).
STEP #4) Slide handle over swivel pipe and tighten retainer knob. (see sketch).

SPECIFICATIONS

At the Rated Operation (Engine Rotational Speed : 6350 min
Active srl
via Delmoncello, 12 - Zona industriale
26037 San Giovanni in Croce
Cremona - Italy
Model MS 8400
Product Date XXXX
*Safety Inclinatin Degree is within 10°.
Fuel Tank Capacity 2.0L

ASSEMBLY INSTRUCTIONS

BOX SPANNER
BANDS(S)
3.2 in.
SWIVEL STRAIGHT
PIPE PIPE
— 2 —
MS 8400
14.4 x 19.1 x 18.7 in. (365 x 485 x 475 mm)
20.7 lbs. (9.4 kg)
Kawasaki/2-Stroke Air cooled TK65 for EPA
64.7 cc
Electric
All position diaphragm
2.1 gal (2.0 lit)
50:1
FLEXIBLE PIPE, SWIVEL PIPE, STRAIGHT PIPE, END PIPE
Vibratin Value : 1.35 m/s 2 (THROTTLE LEVER)
Noise emissions
Sound power level, measured, dB(A) 106
Sound power level, guaranteed, L
WAG
BANDS(S)
4.0 in. OPERATOR'S MANUAL
END PIPE
)
-1
dB(A) 108
HIP BELT
English