Philips HC8800 Mode D'emploi page 7

XP SBC HC 8800/00-1.1
Headphone power supply
IMPORTANT
Use only rechargeable LR03/AAA
NiMH batteries (preferably Philips).
Do not use NiCd batteries or
alkaline batteries as these may damage
your FM wireless system!
1 Check if the power button of the
FM headphone is in the on position.
2 When the red power indicator on the
FM headphone starts flashing, it indicates
that the batteries are running low.
3 To recharge the headphone's built-in
rechargeable LR03/AAA NiMH batteries,
connect the charge cable between the
headphone and the transmitter (figure 3).
Notes:
Completely flat batteries need approximately
16 hours to recharge.
The FM headphone will switch off
automatically during recharging.
Always remove the batteries if the
headphone is not to be used for a long period
of time.
Batteries contain chemical substances,
so they should be disposed of properly.
03-08-2001 16:45
All manuals and user guides at all-guides.com
1 Remove the earcushions.
2 Take out the batteries and dispose of them
3 Insert new batteries. Only use LR03/AAA
4 Make sure the batteries are correctly
5 Put the earcushions back on the earshells.
Pagina 7
Installation
Headphone battery
replacement (figure 4)
IMPORTANT
Use only rechargeable LR03/AAA
NiMH batteries (preferably Philips).
Do not use NiCd batteries or
alkaline batteries as these may damage
your FM wireless system!
properly.
NiMH batteries (preferably Philips).
inserted as indicated by the engraved
symbols in the battery compartment.
IMPORTANT
Before using the FM headphone for the
first time, please ensure that the
batteries are fully charged for about
16 hours.This will guarantee a longer
operating lifetime of the batteries.
7