Publicité
Les langues disponibles
Les langues disponibles
PRODUCT ASSEMBLY
•
First, loosen and remove the L type base screw and washer(15)
from the lower tube(13). Then secure the lower tube(13) on the
round base(14) by the L type base screw and washer(15).
•
Slide the upper tube(11) over the lower Tube(13) and tighten
the Fix knob B(12). Make sure the Fix knob B(12) is tightly
secured.
•
Slide the Connector(9) of the Fan head down over the Upper
Tube(11) and tighten the Fix knob A(10). Make sure the Fix
knob A(10) is tightly secured.
•
Position the Rear Grid(5) against the front of the motor housing,
ensuring that the locating pegs on the motor housing are
engaged correctly in the narrow holes on the Rear Grid(5).
•
Replace and tighten the Plastic Mounting Nut(4). DO NOT
OVER TIGHTEN!
Loosen nut of blade by turning it clockwise to
by turning it anti-clockwise to
Loosen nut of rear guard by turning it anti-clockwise to
tighten it by turning it clockwise to
•
Push the Fan Blade(3) onto the Motor Shaft(6), locating the slot
on the back of the Fan Blade(3) on to the drive pin that passes
through the Motor Shaft(6).
•
Tighten the Blade Cap(2) by turning it anticlockwise.
•
Position the Front Grid(1) against the Rear Grid(5) so that the
slot in the rims can fit the Rear Grid(5). Lock the clip on the front
Grid(1), and fix the safety screw.
.
.
6
, and tighten it
, and
Publicité
