Dometic PRO TALL AIR ANNEXE Guide D'utilisation page 3

WELCOME
Thank you for purchasing your Dometic annexe. Please read these instructions carefully before attempting
set up and retain for future reference. If used properly, your annexe should give you years of trouble free
use. We recommend that your annexe is insured against accidental storm damage as this is not covered by
the warranty.
UV DEGRADATION
Fabrics can be weakened by prolonged exposure to sunlight. Under normal
holiday use your annexe will give long service but use for extended periods
in strong sunlight will soon cause deterioration. In those cases it would be
wise to use a site as shaded as possible. UV degradation is not covered
under the warranty. The warranty does not cover products on permanent
sites, displays or for commercial purposes.
Your awning and annexe are designed for use in light to moderate weather. During very
strong winds or snowfall we recommend that you take your awning down. The awning
is designed for touring use; it is not designed for seasonal pitch (except All-Season) or
commercial use.
We recommend a trial run before using your awning for the first time. This will allow you to
familiarise yourself with the awning, its set up and any limitations the awning and annexe
may have for your particular use.
SET-UP
The annexe can be fitted to either side off the awning, or both. The side panels can also be reversed.
1. Remove the relevant side panel from the awning by unpegging and unzipping the panel.
2. Zip the annexe into place of the panel.
3. Unscrew the top cap of the inflation valve and attach the pump nozzle.
4. Start to pump. The ideal inflation pressure is 9psi (0.62 bar).
5. Once inflated, pull or push the front of the annexe outwards so that the AirPoles can assume their correct
shape.
6. Peg out the annexe starting with the two corners closest to the awning and the annexe.
7. Tall AIR Annexe and Conservatory AIR Annexe only: Inside the annexe, attach the internal spreader bar
between the awning and the annexe. The spreader bar should be tensioned to ensure that the roof is taut.
8. Peg out the guy lines.
9. Ensure that the sides and the roof of the annexe are taut. If necessary, re-peg.
10. AIR Annexe and Tall AIR Annexe only: The inner tent can be attached to the annexe using the supplied
buckles and "O" rings on the inside of the annexe. The front two corners of the inner tent groundsheet
should be pegged.
11. Tall AIR Annexe and Conservatory AIR Annexe only: The divider can attached using the supplied "O" rings
on the inside of the annexe.
DUKA-AIR-ANX-UM-0820
3