KBS AB.8/D Emploi Et Entretien page 20

Using the mincer
•
In combined grater-mincer versions, lower the grater lever.
•
Tighten the filler knob.
•
Tighten the handwheel on the output mouth of the mincer without blocking.
•
Start-up the machine by pressing start button "I" (in combined models start-up is only possible if the
grater lever is lowered).
•
Place the product inside the upper mincer mouth and press it down using the pestle supplied.
•
At the end of the work session press the stop button "0".
•
At the end of the work cycle remove the mincer set and wash using suitable detergents in hot water .
The appliance is intended for intermittent use only.
It is not designed for continuous operation. Duty cycles must be less than 20 minutes.
The appliance may warm up during use: this is normal.
Dismantling the mincer set
Mod.AB.8/D – TR.8/D:
•
Remove the hopper from the upper mouth.
•
Rotate the handwheel anti-clockwise.
•
Extract:
the mincing plate;
-
- the blade;
and the volute, in sequence
-
•
Unscrew the filler knob by turning anti-clockwise
and extract the mincer filler.
•
Perform operations
reassemble the mincer group.
INFORMATION: Prior to each work cycle ensure that the removable parts are properly fixed
End-of-day cleaning
•
At the end of the working day remove the plug from the power socket.
•
Clean thoroughly using neutral products.
•
Wash the outer part of the machine using a damp sponge.
•
Do not use steel wool or abrasive pads.
•
Dismantle the mincer set and wash using suitable detergents in hot water. Do not wash it in the
dishwasher.
Long periods of inactivity
If the machine is to be left idle for long periods of time, turn off the main wall switch, thoroughly clean the
machine and cover it with a sheet to protect it from dust.
in reverse order to
to the machine.
OPERATION AND
10
3
CLEANING