Black & Decker KD975 Traduction Des Instructions D'origine page 7

switched off and when it is running idle in addition
to the trigger time.
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the
user must read the instruction manual.
Electrical safety
This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on
the rating plate.
♦ If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised
Black & Decker Service Centre in order to
avoid a hazard.
Features
This tool includes some or all of the following
features.
1. Variable speed switch
2. Lock-on button
3. Forward/reverse switch
4. Variable speed control knob
5. Drilling mode selector
6. Tool holder
7. Side handle
8. Depth stop
Assembly
Warning! Before assembly, make sure that the tool
is switched off and unplugged.
Fitting the side handle and depth stop (fi g. A)
♦ Turn the grip counterclockwise until you can
slide the side handle (7) onto the front of the
tool as shown.
♦ Rotate the side handle into the desired
position.
♦ Insert the depth stop (8) into the mounting hole
as shown.
♦ Set the depth stop to the desired position. The
maximum drilling depth is equal to the distance
between the tip of the drill bit and the front end
of the depth stop.
♦ Tighten the side handle by turning the grip
clockwise.
Fitting an accessory (fi g. B)
♦ Clean and grease the shank (9) of the
accessory.
♦ Pull back the sleeve (10) and insert the shank
into the tool holder (6).
All manuals and user guides at all-guides.com
♦
♦
♦
KD985/KD990 - Fitting the keyed chuck (fi g. C)
♦
Warning! Never use keyed chucks in the hammer
drilling mode.
KD985/KD990 - Fitting accessories in the keyed
chuck (fi g. D)
♦
♦
♦
Residual risks.
Additional residual risks may arise when using the
tool which may not be included in the enclosed
safety warnings. These risks can arise from misuse,
prolonged use etc.
Even with the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks can not be avoided.
These include:
♦
♦
♦
♦
♦
Use
Warning! Let the tool work at its own pace. Do not
overload.
Warning! Before drilling into walls, fl oors or ceilings,
check for the location of wiring and pipes.
Selecting the operating mode (fi g. E)
The tool can be used in three operating modes.
Rotate the drilling mode selector (5) towards the
required position, as indicated by the symbols.
ENGLISH
Push the accessory down and turn it slightly
until it fi ts into the slots.
Pull on the accessory to check if it is properly
locked. The hammering function requires the
accessory to be able to move axially several
centimetres when locked in the tool holder.
To remove the accessory, pull back the sleeve
(10) and pull out the accessory.
Fit the shank (11) of the supplied chuck (12)
into the tool holder as described above.
Open the chuck by turning the sleeve (13).
Insert the bit shaft (14) into the chuck.
Insert the chuck key (15) into each hole (16) in
the side of the chuck and turn until tight.
Injuries caused by touching any rotating/
moving parts.
Injuries caused when changing any parts,
blades or accessories.
Injuries caused by prolonged use of a tool.
When using any tool for prolonged periods
ensure you take regular breaks.
Impairment of hearing.
Health hazards caused by breathing dust
developed when using your tool (example:-
working with wood, especially oak, beech
and MDF.)
7