Black & Decker KD975 Traduction Des Instructions D'origine page 6

ENGLISH
b. Do not use the power tool if the switch
does not turn it on and off. Any power tool
that cannot be controlled with the switch is
dangerous and must be repaired.
c. Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk of
starting the power tool accidentally.
d. Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e. Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tools operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g. Use the power tool, accessories and
tool bits etc., in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended could
result in a hazardous situation.
5. Service
a. Have your power tool serviced by
a qualifi ed repair person using only
identical replacement parts. This will ensure
that the safety of the power tool is maintained.
Additional power tool safety warnings
Warning! Additional safety warnings for
rotary and chiselling hammers.
♦ Wear ear protectors. Exposure to noise can
cause hearing loss.
♦ Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
♦ Hold power tool by insulated gripping
surfaces when performing an operation
where the cutting accessory may contact
hidden wiring or its own cord. Cutting
6
All manuals and user guides at all-guides.com
♦
♦
♦
♦
♦
Safety of others
♦
♦
Vibration
The declared vibration emission values stated in
the technical data and the declaration of conformity
have been measured in accordance with a standard
test method provided by EN 60745 and may be used
for comparing one tool with another. The declared
vibration emission value may also be used in
a preliminary assessment of exposure.
Warning! The vibration emission value during actual
use of the power tool can differ from the declared
value depending on the ways in which the tool is
used. The vibration level may increase above the
level stated.
When assessing vibration exposure to determine
safety measures required by 2002/44/EC to protect
persons regularly using power tools in employment,
an estimation of vibration exposure should consider,
the actual conditions of use and the way the tool is
used, including taking account of all parts of the
operating cycle such as the times when the tool is
accessory contacting a „live" wire may make
exposed metal parts of the power tool „live"
and shock the operator.
Never use a chisel accessory in rotary mode.
The accessory will bind in the material and
rotate the drill.
Use clamps or another practical way to secure
and support the workpiece to a stable platform.
Holding the work by hand or against your body
leaves it unstable and may lead to loss of
control.
Before drilling into walls, fl oors or ceilings,
check for the location of wiring and pipes.
Avoid touching the tip of a drill bit just after
drilling, as it may be hot.
The intended use is described in this instruction
manual. The use of any accessory or
attachment or performance of any operation
with this tool other than those recommended
in this instruction manual may present a risk of
personal injury and/or damage to property.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.