Honeywell HS-2007 Serie Guide D'utilisation page 3

• Place Base Extensions
(A) as illustrated and
snap Base Connector (B)
firmly onto Base
Extensions (Fig. 1).
• Insert the Adjustable
Pole (C) into the Base by
lining up the recessed
slot in the Pole to the
Fig. 1
B
• Place the Motor
Assembly (E) onto the
Adjustable Pole and
screw into place by
turning Clockwise (Fig.
4). Align the slot to slide
the latch into place (Fig.
5). NOTE: The tilt angle
of the Motor Assembly
can be changed by
simply tilting the Motor
up or down.
• Remove the Blade
Knob (F) and the Rear
Grille Mounting Nut (G).
Place the Rear Grille (H)
All manuals and user guides at all-guides.com
ASSEMBLY INSTRUCTIONS
raised dot on the Base
Connector and push in.
Be sure that the Pole is
fully seated. Hold the
Base firmly and twist the
Pole CLOCKWISE 90°
until it stops. DO NOT
OVER-TIGHTEN (Fig. 2).
Fig. 2
A
ATTACHING THE MOTOR ASSEMBLY
onto theMotor Housing
by making sure the 3
holes of the Rear Grille
fit over the 3 bumps on
the Motor Housing.
Tighten the Rear Grille
Mounting Nut
CLOCKWISE. (Fig. 6)
Fig. 4
F
• Adjust to the desired
height and tighten the
Height Adjustment Knob
(D) (Fig. 3).
Fig. 3
C
D
HEIGHT
ADJUSTMENT KNOB
TO THE FAN POLE
Fig. 5
E
Fig. 6
G
H