Connections - Teac SR-100i Mode D'emploi

After all connections are complete, connect the power cord's plug to the AC wall socket.
< Read the instructions of each device that you intend to use with this unit.
< Be sure to connect each plug securely. To avoid hum and noise, do not bundle the connection cords.
Back
A AUX in jacks
These jacks transmit an analog 2-channel audio signal.
Connect a portable audio player using commercially
available RCA pin-stereo mini plug cable.
Be sure to connect the cables as follows:
White plug e White jack (L: left channel)
e Red jack (R: right channel)
Red plug
< When using the headphones jack of the component,
if you do not adjust its volume, you might not hear
any sound from SR-100i.
< Turning the volume of the connected component
up too high might cause the sound from SR-100i to
be distorted. In this case, reduce the volume of the
component until the distortion stops and then adjust
the volume level of SR-100i to a comfortable listening
level.
< Be sure to insert each plug securely. To prevent hum
and noise, avoid bundling the signal interconnection
cables together with the AC power cord or speaker
cables.

Connections

A
(Optional cable)
B
C
D
B FM ANTENNA terminal
Connect the supplied FM antenna. Extend fully and
position for the best reception and attach it to a
window frame or wall with thumbtacks or the like.
C USB (
You can connect a USB storage device to this port
using the supplied USB cable.
D AC in
After all other connections have been completed,
connect the plug to an AC wall socket.
Be sure to connect the power cord to an AC outlet
which supplies the correct voltage.
Hold the power plug when plugging or
unplugging the power cord.
Portable audio
player
USB flash memory
AC wall socket
) port
9