Maintenance - Greencut GHT260X Manuel D'utilisation

50
USE
• Use the starter only to the extent necessary for the job. Excessive engine speed is unnecessary.
• Avoid cutting thick branches as they may damage the blades and shorten the life of the appliance.
• Tilting the hedge trimmer 5 to 10° towards the cutting object will make the job easier.
• Always keep your body on the side of the carburetor, never on the side of the muffler.
• When using the machine for the first time, grass may come out of the transmission during the first few minutes.
But since it's leftover weed, it's no cause for alarm. Simply remove it with the motor stopped before the next use.

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
SYSTEM/
COMPONENT
Fuel stains
Fuel tank, air filter, fuel
filter
Idle adjustment screw
Spark plug
Cylinder fins, air inlet fan
Silencer, spark arrestor,
cylinder exhaust port
Throttle lever, ignition
button
Cutting parts
Gearboxes
Screws/bolts
BEFORE
PROCEDURE OF
USE
Dry
Inspect/Clean
See "ADJUSTING
THE SPEED OF THE
RENTÍ".
Clean and reset the
electrode gap
Cleaning
Inspect
Change if there is
something wrong
Lubrication system
Adjust/change
EVERY EVERY
25 50
HOURS HOURS
x
x x
x
x
x
x
x
x
x
x
EVERY 100
NOTE
HOURS
Change if
necessary
Change if
necessary
Separation: 0.6-
0.7mm. Change
if necessary
There are screws
x
that do not fit