Operation; Selecting The Operating Mode; Sensor Mode - Heidolph Hei-VOLUME Distimatic Pro Notice D'instructions

Operation

Operation

Selecting the operating mode

After switching on the device and initializing the device control, the start window of the last
active operating mode appears on the display. Touch the
Applications
menu and to activate the desired mode (see section „Applications menu" on
page 107).

Sensor mode

Activating sensor mode
Applications
➜
Open the menu
entry is highlighted in orange.
➜
Confirm the selection with
window:
In sensor mode, the filling quantity in the evaporation flask is regulated by the flask level
sensor S4. The following sensor statuses are possible:
➜
The filling process is started and runs as long as the sensor does not have contact with the
medium → S4 in the status
➜
The filling process is stopped when the sensor comes into contact with the medium → S4
high
in the state ,.
and touch the function button
ok
to activate the mode and to open the sensor mode start
low
.
120
Mode
function button to open the
Sensor mode
. The