Uline DESIGNER H-9806 Mode D'emploi page 2

Figure 2
Figure 3
Figure 4
PAGE 2 OF 6
ASSEMBLY CONTINUED
C
H
E
F
D
G
1-800-295-5510
4. Unlock drawers and slowly open bottom drawer.
Attach drawer caster (C) to the underside of bottom
drawer using three ST3.5 x 14 mm screws (H) and drill.
(See Figure 2)
5. Place pedestal file upright. Remove pre-attached
handles (E) from inside of drawer and move to
the outside of drawers. Align holes on drawer with
holes on handle and attach using two M4 x 34 mm
screws (F). Repeat for other drawers. (See Figure 3)
6. Attach file clips (D) to each side of the bottom
drawer and insert metal bar (G). (See Figure 4)
uline.com
0322 IH-9806