Publicité
ANTI-TIP SAFETY HARDWARE INSTALLATION
WARNING
• Serious or fatal crushing injuries can occur from furniture tip-over. To help prevent tip-over:
- Place heaviest items in the lower drawers.
- Do not set TV's or other heavy objects on the top of this product unless the product is specifically
designed to accommodate them.
- Never open more than one drawer at a time.
- Never allow children to climb or hang on drawers, doors, or shelves.
- Do not defeat or remove the drawer interlock system.
- Use of tip-over restraints may only reduce, but not eliminate, the risk of tip-over.
- Install tip-over restraint provided.
• This product is only a deterrent. It is not a substitute for proper adult supervision. Manufacturer
assumes no liability for improper installation or excessive loads placed on screws, brackets or straps.
• Young children may be injured by tipping furniture and the use of a tipping restraint is highly
recommended.
• When properly installed, this restraint will provide protection against tipping of furniture. This tipping
restraint must be secured to a wall-stud or wall structure of similar strength.
FURNITURE TIPPING RESTRAINT HARDWARE INCLUDED:
• Brackets, 42*20mm (2).
• Nylon Strap, 250mm (1).
• Stud Mounting Screws, 50mm (2).
• Product Side Mounting Screw, 20mm (2).
• Expansion nut, 35mm (2).
NOTE:
• For safe mounting it is essential to use the proper hardware for your wall type. The included hardware
is for stud mounting only.
• If the mounting bracket cannot be secured to a wall stud be cause of inappropriate spacing and/or
because you have a different wall type (e.g., plaster, concrete, brick etc.) please consult your local
hardware store for fastener advice.
TO INSTALL:
1) LOCATING THE STUDS: Use a stud finder to locate the vertical wooden studs within your wall
located behind the final position of the furniture item. Mark the stud locations with a light
pencil-mark.
2) 2) MOUNTING THE FURNITURE-SIDE BRACKET: Move the furniture item close to the wall to its final
position. Use pieces of tape or a pencil to transcribe the stud locations of the wall onto the furniture
item. Move the furniture item again so you can access its back and use the marks to locate a suitable
mounting point for the furniture-side bracket. Make sure that the bracket is secured to a firm portion
of the furniture frame and as high as possible.
Remember: The furniture-side bracket must be positioned near a wall stud. Using a pencil, and the
bracket as a guide, mark "screw marks" on the furniture item through the bracket holes
Use a 3/32" drill bit to drill pilot holes into the furniture item at the "screw marks". Secure the
expansion nuts in place prior to using the two short screws to secure the furniture side bracket. This
bracket can be positioned either vertically or horizontally as necessary (Refer to zoomed-in
illustration).
www.dreamonme.com/help
29
Publicité
