Starting Operation - Bosch EasyLamp 12 Notice Originale

OBJ_BUCH-3004-002.book Page 14 Thursday, January 5, 2017 10:37 AM
14 | English
Assembly
Battery Charging (Accessory) (see figure A)
 Use only the battery chargers listed on the accessories page. Only these bat-
tery chargers are matched to the lithium ion battery of your cordless worklight.
Note: The battery supplied is partially charged. To ensure full capacity of the battery,
completely charge the battery in the battery charger before using your power tool for
the first time.
The lithium-ion battery can be charged at any time without reducing its service life. In-
terrupting the charging procedure does not damage the battery.
The lithium-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.
Do not continue to press the On/Off switch after the cordless worklight has been
automatically switched off. The battery can be damaged.
To remove the battery 3, press the battery unlocking button 4 and pull the battery out
of the cordless worklight toward the rear. Do not exert any force.
Observe the notes for disposal.
Operation

Starting Operation

Inserting the battery
 Use only original Bosch lithium-ion batteries with the voltage listed on the
nameplate of your cordless worklight. Using other batteries can lead to injuries
and pose a fire hazard.
Insert the charged battery 3 into the handle until it can be felt to engage and faces
flush against the handle.
Switching On and Off
 The cordless worklight produces a light beam that emerges from the lamp
head 1.
To start the cordless worklight, press the On/Off switch 2.
To switch off the cordless worklight, press the On/Off switch 2 again.
To save energy, only switch the cordless worklight on when using it.
1 609 92A 3P9 | (5.1.17) Bosch Power Tools