Sony SU-WL850 Informations D'installation page 13

5
Install on the wall using
WM1
suitable screws (not supplied)
and washers (not supplied).
× 4
Note
 Use a level to check whether
Precaution
 Do not over-tighten wooden screw 8 mm × 60 mm.
Improper tightening could reduce the holding
power of wooden screw 8 mm × 60 mm.
6
Pull out the arm of the bracket to
the end.
WM1
8 mm × 60 mm
WM1
is level.
− 13 (EN) −
Preparing for the Installation
of the TV or LCD Monitor
Note
 Be sure to store the removed screws and unused parts
in a safe place, keeping them away from children.
1
Attach the Table-Top Stand to
make the TV or LCD Monitor
standing.
• Refer to your TV's or LCD Monitor's Setup
Guide.
2
Remove the screws from the rear
of the TV or LCD Monitor.
3
Attach the Wall-Mount
Attachment
VS
the TV or LCD Monitor) to the
rear of the TV or LCD Monitor (to
make it parallel with the wall).
VS
(supplied with
1.5 N·m
{15 kgf·cm}
EN