Télécharger Imprimer la page

Ferguson ProFlo PF1705 1710 Instructions D'installation

Réservoir de gravité à sortie arrière de type mural

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Installation Instructions
Wall Hung Back Outlet
Gravity Tank
PF1705 / 1710
BOLT
WASHER
NUT
1. Follow closet carrier support installation
instructions. Confirm the carrier support studs
extend a minimum of 1 7/8", 48mm from face
of the finished wall.
2. Place back up nuts on top left and bottom two
bolts. Adjust the nuts so the front face of the nuts
are flush with the finished wall. Use a hack saw
blade to gauge recommended tolerances of 1/16"
gap between the fixture and the wall surface.
3. Adjust the waste horn so that 5/16" (7mm)
extends past the finished wall.
4. Follow the manufactures closet carrier support
recommendations setting of closet outlet connection.
5. Use felt or rubber gasket, (wax ring is not
recommended) on closet outlet.
6. With a helper, carefully mount the bowl onto
the carrier studs using fiber washers and cap
nuts. Hand tighten. DO NOT apply top right fiber
washer and cap until the other three nuts are
firmly tightened. Hand tighten top right cap nut.
7. Apply silicon sealant between bowl and finished wall.
8. Install the tank-to-bowl-gasket, tank bolts with
washer if it is not already installed, and place
tank on bowl.
9. Snug and level the tank nuts using a socket
wrench and holding the truss head screw
firmly inside the tank with a screwdriver.
10. Connect the water supply to the ballcock. Only
hand tighten the supply line. DO NOT USE
CHANNEL LOCKS.
11. Turn on water, flush and check for leaks.
Adjust ballcock to proper water line height as
noted on the flush valve tube.
© 2010 Ferguson Enterprises, Inc. All Rights Reserved
Water Level Adjustment
RUBBER
Rotating adjustable rod will adjust the height of
GASKET
float cup and change water level.
MOULD 2001
FLOAT CUP
FILL VALVE BODY
TRIANGLE GASKET
RUBBER SEAL
PLASTIC SEAL
HEXAGONAL SEAL
Care & Maintenance
Do not use abrasive powered or liquid cleaners
which can damage the product surface DO
NOT USE IN-TANK TOILET BOWL CLEANERS
CONTAINING BLEACH OR CHLORINE Could
Result in Damage to tank components and may
cause flooding and property damage.
Caution
Product is Fragile. To avoid Breakage and possible
injury handle with care! Over tightening of Lock
Nut or coupling nut could result in breakage and
flooding. Do Not Use cone washer with plastic
supply line. Do Not Use pipe dope or other silicon
based materials to tighten supply coupling nut.
Warranty
WHAT IS COVERED?
Ferguson Enterprises, Inc. "Ferguson" or the "Company"
warrants its products to be free from defects in material
and workmanship under normal use and service FOR
A PERIOD OF ONE (1) YEAR FROM THE DATE OF
INSTALLATION.
WHAT IS NOT COVERED?
The warranty set forth in paragraph 1 does not cover
installation or any other labor charges and does not apply
to products which have been damaged as a result of any
accident, abuse, improper installation or maintenance,
Distributed Exclusively by Ferguson and Wolseley Canada
or modification of original plumbing product. The
warranty of such products is limited to the warranty
extended to Ferguson by the product manufacturer.
Finally, FERGUSON SHALL NOT BE RESPONSIBLE
OR LIABLE FOR ANY FAILURE OR DAMAGE TO THIS
PRODUCT OR ANY COMPONENT THEREOF CAUSED BY
ADJUSTABLE ROD
THE USE OF ABRASIVE CLEANERS.
HOW TO OBTAIN WARRANTY SERVICE
US Customers:
The purchaser should contact their local Ferguson
location, installing contractor or builder from whom the
product was purchased. To find you nearest Ferguson
location please visit www.ferguson.com and enter in
your address into the Find a Location field.
Canadian Customers:
The purchaser should contact their local Wolseley
Canada location, installing contractor or builder from
whom the product was purchased. To find your nearest
Wolseley Canada location please visit www.wolseleyinc.
ca, then click on Find a Location and enter your address
FILTER
into the location field.
PROFLO is a registered trademark of Ferguson
Enterprises, Inc.
LIMITATIONS
DISCLAIMER OF CONSEQUENTIAL OR INCIDENTAL
DAMAGES FERGUSON DISCLAIMS ANY LIABILITY
FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES AND
DISCLAIMS ALL EXPRESS OR IMPLIED WARRANTIES,
INCLUDING THOSE OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, AS SET
FORTH ABOVE. IMPLIED WARRANTIES OF THE
PRODUCTS AND PRODUCT COMPONENTS SET
FORTH IN PARAGRAPH 1 ABOVE ARE LIMITED TO
THE DURATIONS OF THE RESPECTIVE WARRANTY.
Some states do not allow the exclusion or limitation
of incidental or consequential damages or limitations
on how long an implied warranty lasts, so the above
limitations may not apply to you. This warranty gives
you specific legal rights and you may also have other
rights, which vary from state to state.
OF
IMPLIED
WARRANTY
AND
6635 12/10

Publicité

loading

Sommaire des Matières pour Ferguson ProFlo PF1705 1710

  • Page 1 US Customers: The purchaser should contact their local Ferguson location, installing contractor or builder from whom the product was purchased. To find you nearest Ferguson FILL VALVE BODY location please visit www.ferguson.com and enter in 1. Follow closet carrier support installation your address into the Find a Location field.
  • Page 2 1. Result in damage to tank components and may cause flooding and property damage is nut is tight. 2. Void warranty Reassemble in reverse order to assure functioning Distributed Exclusively by Ferguson and Wolseley Canada 6635 12/10 © 2010 Ferguson Enterprises, Inc. All Rights Reserved...
  • Page 3: Réservoir De Gravité À Sortie Arrière De Type Mural

    ÉCROU TIGE AJUSTABLE plomberie original. La garantie de ce produit se limite à la garantie offerte à Ferguson par le fabricant du produit. CUVETTE DU FLOTTEUR Enfin, FERGUSON NE PEUT ÊTRE TENU RESPONSABLE DES BRIS OU DES DOMMAGES DE CE PRODUIT OU 1.
  • Page 4: Dépannage

    à la cuvette. Vérifier si le clapet est usé, sale ou désaligné. Remplacer le clapet fonctionnement. avec un clapet de remplacement d’origine. Vérifier si l’écrou du robinet de la chasse est bien serré. Distributed Exclusively by Ferguson and Wolseley Canada 6635 01/11 © 2010 Ferguson Enterprises, Inc. All Rights Reserved...
  • Page 5: Cuidado Y Mantenimiento

    Use la hoja de una sierra para SELLO DE PLÁSTICO se le compró el producto. Para buscar a tienda Ferguson más metales para calibrar las tolerancias de holgura de cercana visite www.ferguson.com e ingrese su dirección en el 1/16”...
  • Page 6: Solución De Problemas

    Reemplace la clapeta con una original de repuesto. Verifique que la tuerca de la válvula de descarga esté apretada. Distributed Exclusively by Ferguson and Wolseley Canada 6635 01/11 © 2010 Ferguson Enterprises, Inc. All Rights Reserved...