Ghibli & Wirbel POWER TOOL PRO FD 36 P COMBI M Utilisation Et Entretien page 20

- Re-mount the floater-holder (3 Fig. 25),
with the "FRONT" arrow aligned with the
front part of the machine (38 Fig. 25);
also re-mount the cover (2 Fig. 25) and
block it via the levers (1 Fig. 1).
- Insert, as far as possible, the sleeve (8
Fig. 5) of the suction hose into the nozzle
(9 Fig. 5) on the drum.
- To release the sleeve (8 Fig. 5) turn the
lever (10 Fig. 5) clockwise and then pull
the sleeve outwards (8 Fig. 5).
- Attach a crevice tool (12 Fig. 6) or dusting
brush (13 Fig. 6) to the flexible hose (11
Fig. 6) depending on the type of cleaning
to be performed.
- If provided, attach the extension wand
(14 Fig. 7), to the hose (11 Fig. 7), fol-
lowed by the required accessory (suction
nozzle, floor nozzle, etc. Fig. 8).
Tools connection
NOTE:
A relevant hose is supplied for these types of
machine, with suitable tool attachments.
Power tool connection
For appliances fitted with relative outlet.
- Lift the cover (15 Fig. 9) and connect
the power tool plug to the outlet (16 Fig.
9) present on the head of the vacuum
cleaner (maximum power allowed 2000
W).
Pneumatic tool connection
For appliances
attachments.
- Connect the hose (17 Fig. 9) of the
pneumatic tool to the relative fitting (18
Fig. 9) present on the head of the vacuum
cleaner.
- Connect the pneumatic power supply line
(19 Fig. 9) to the fitting (20 Fig. 9) present
on the head of the vacuum cleaner
(maximum pressure allowed 10 bar).
fitted with relative
Liquid suction
WARNING:
Risk of electric shock!
In the event of foam or liquid leakage,
switch off the apparatus immediately.
Empty the recovery tank and clean the
filters as described in the relevant sec-
tions.
NOTE:
Regularly check that the floater is operating
correctly as described in the relevant section.
For appliances equipped with suitable acces-
sories.
- Release the levers (1 Fig. 1) and remove
the cover (2 Fig. 2) complete with the mo-
tor unit and floater-holder (3 Fig. 2).
- Remove the polyester filter (4 Fig. 3) if
present.
- Remove the fleece bag (5 Fig. 3) if pres-
ent.
- Re-mount the floater-holder (3 Fig. 25),
with the "FRONT" arrow aligned with the
front part of the machine (38 Fig. 25);
also re-mount the cover (2 Fig. 25) and
block it via the levers (1 Fig. 1).
- Insert, as far as possible, the sleeve (8
Fig. 5) of the suction hose into the nozzle
(9 Fig. 5) on the drum.
- To release the sleeve (8 Fig. 5) turn the
lever (10 Fig. 5) clockwise and then pull
the sleeve outwards (8 Fig. 5).
- Attach a crevice tool (12 Fig. 6) or dusting
brush (13 Fig. 6) to the flexible hose (11
Fig. 6) depending on the type of cleaning
to be performed.
- If provided, attach the extension wand
(14 Fig. 7), to the hose (11 Fig. 7), fol-
lowed by the required accessory (suction
nozzle, floor nozzle, etc. Fig. 8).
ENGLISH - 4
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968