Using The Ir Blaster - Panasonic SC-HTB880 Manuel D'utilisation

∫ HDMI standby pass-through
Even if the main unit is in standby mode, the audio and/or video signal from the device connected to the HDMI AV IN1 or
HDMI AV IN2 terminal will be sent to the TV that is connected to the HDMI AV OUT terminal. The sound will not be output
from this system's speakers. When devices are connected to both HDMI AV IN1 and HDMI AV IN2 terminals, the audio and/
or video signal of the device that was last used is selected as the output.
∫ 3D compatibility
Compatible with FULL HD 3D TV and Blu-ray Disc player.
≥ The main unit can pass-through the 3D video signal from a 3D compatible Blu-ray Disc player to a FULL HD 3D TV.
∫ 4K/60p compatibility
Compatible with 4K Ultra HD TV and Blu-ray Disc player.
≥ This system can pass-through the 4K content of 4K compatible equipment to a 4K Ultra HD TV.
≥ When connecting to 4K compatible equipment and 4K Ultra HD TV, use High Speed HDMI cables which support 18 Gbps
bandwidth.
≥ Refer to the operating instructions of the connected HDMI compatible device for the settings required to output the video and
audio signals.

Using the IR Blaster

With the IR Blaster connection, it is possible to send the IR signal received by this system's remote
control signal sensor to the TV's sensor.
Use the TV's remote control within the operation range of this system's remote control signal sensor.
≥For the operation range, refer to page 8.
Connect the jack plug to the main unit's Ir SYSTEM terminal.
Ir SYSTEM
Place the infrared emitter in sight of the TV's remote control signal
sensor.
≥ For the location of the TV's remote control signal sensor, refer to the operating instructions for the TV.
Aim the TV's remote control at this system's remote control sensor and
operate the TV.
≥ For the location of this system's remote control signal sensor, refer to page 8.
≥ Make sure to clean the surface, where the adhesive tape is to be attached.
≥ If you peel off the adhesive tape, the surface may become damaged and exposed adhesive may remain. Once you have
confirmed the TV is operating correctly, secure it by attaching the adhesive tape.
Infrared emitter
RQT9903
11