Makita DBS180 Manuel D'instruction page 6

Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Adjusting arm inclination
The arm can be pivoted and fixed at any desired angle
within the range "A" (-5° to 90°) in the figure. Adjust the
angle to make a comfortable working position.
Loosen the lock lever by raising it. Pivot the arm to the
desired position, and secure the lock lever to fix the arm
firmly.
1
► 1. Lock lever 2. Arm
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
2
"A"
Replacing arm
6 mm (1/4") and 13 mm (1/2") width belts can be
installed with the optional arms that are designed for
the corresponding belt widths. Loosen the screw that
secures the arm and replace the standard-equipped
arm with the optional arm, then tighten the screw firmly.
1
► 1. Screw 2. Arm
Switch action
WARNING:
For your safety, this tool is equipped
with the lock-off switch which prevents the tool from
unintended starting. NEVER use the tool if it runs when
you simply pull the switch trigger without releasing the
lock-off switch. Return the tool to our authorized ser-
vice center for proper repairs BEFORE further usage.
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released. Operating a tool
with a switch that does not actuate properly can lead
to loss of control and serious personal injury.
NOTICE:
Do not pull the switch trigger hard without releas-
ing the lock-off switch. This can cause switch breakage.
NOTICE:
The lock-off switch cannot be released
while the arm is being pivoted beyond 90°.
To prevent the switch trigger from being accidentally pulled, a lock-
off switch is provided. Depress the switch lever (
to unlock the switch trigger, and (
► 1. Lock-off switch
6 ENGLISH
2
) from the A side
) from the B side to lock in.
1
A
1
B