General Operation - McCulloch MC1350 Mode D'emploi

GENERAL OPERATION

NOTE: Be sure that Water Reservoir has been filled and that all desired accessories are
connected before following these steps.
1. For first time use, remove protective plastic cover from electrical plug. Plug power cord into a
electrical outlet.
2. Switch On/Off Switch to "On" position. Within 30 seconds, the Steam Ready Light will illumi-
nate green indicating the unit is ready for use.
NOTE: For first time use or after a prolonged storage time, there may be a slight delay for
steam due to a dry Water Treatment Cartridge.
3. Direct Nozzle (and any connected accessory) towards surface you desire to steam, and press
Steam Trigger. To sanitize surfaces, point Nozzle, press Trigger and hold approximately 1/2 inch
from surface for at least 5 seconds. This will insure that you have killed germs and bacteria.
CAUTION: Always be sure that Nozzle and any accessory are pointed in a safe direction
(away from yourself, other people, pets, and plants) before pressing Steam Trigger.
4. Keep Steam Trigger pressed for a continuous flow of steam. You may also hold the Steam Trig-
ger, then push the Steam Trigger Lock to lock it down. This will allow a continuous flow of steam
without need of holding the Steam Trigger down manually. Steam output can be adjusted by
simply turning the Steam Adjustment Knob.
5. Using a back-and-forth motion over the area you are steaming will further enhance the clean-
ing process. Wipe steamed areas with a clean cloth to remove loosened dirt and grime. Wip-
ing the area while it is still wet is recommended, but use caution when wiping surfaces such as metal
that may still be hot.
6. Once steaming tasks are complete, turn the unit "Off" and unplug. Follow steps under Proper
Storage procedure on Page 13 of this manual.
12 | ENGLISH
Using Your Portable Power Steam
Cleaner