Edenwood MEGASOUND Consignes D'utilisation page 27

B
Product usage
BASS All modes
All modes
6. When the speaker is not used for 10 minutes it will automatically turn off. Press the
button to turn it on again.
7. Press the button to turn off the speaker.
8. Unplug the speaker to turn it off fully.
FM Radio
• Unwind the FM antenna (at the back of the speaker).
• Press the button repeatedly to select RADIO mode. The frequency will display on the
screen, for example 90.30.
• Press and hold the
show on the display, for example P - - 01.
• Press and hold the
• Press button to switch between preset station and frequency.
• When the stored station (for example P - - 01) is displayed on the screen, press
to skip to the next or previous station.
• When auto scanning has stopped and the radio frequency (for example 90.30) is displayed,
press and hold the
NOTE: You can store up to 30 stations. The actual number of stored stations
depends on the reception in your area. Once stored, the stations will be saved
even if you turn off the speaker.
Microphone
You can connect up to 2 microphones (not provided) to sing karaoke or create a loudspeaker
system to communicate with a large audience.
• Connect a microphone cable (not provided).
• Turn the MIC VOL knob to adjust the microphone volume.
• If there is an echo when using the microphone, adjust the MIC ECHO knob until there is
little or no echo.
• Turn the MIC REVERB knob to adjust sound reverberations from the environment.
• When you have finished using the microphone, unplug the cable from the speaker.
WARNING:
• Never hold the microphone too close to the speaker as this may cause feedback.
Press to turn the bass on or off. BASS ON will display
when the bass is on, and BASS OFF will display when it
is off.
Press repeatedly to select either ROCK, JAZZ, SAMBA,
POP or BALAN (balance) sound reproduction.
button to automatically scan. The number of the stored station will
button again at any time to stop auto scanning.
or button to fine tune the radio channel.
25 EN
or