Edenwood MEGASOUND Consignes D'utilisation page 25

B
Product usage
2. Plug the power cord into the wall socket and press the
sound prompt will play, and HELLO will display on the screen. The speaker will automatically
start searching for a Bluetooth device and BT will flash on the display to confirm it is
searching.
3. If the speaker does not automatically start searching for a Bluetooth device, press and
hold button. The speaker will then automatically start searching for a new or existing
Bluetooth device.
4. When the Bluetooth device displays the speaker's Bluetooth name, EDENWOOD
MEGASOUND, select the name and confirm the connection. When pairing is successful,
a sound prompt will play, and BT will display constantly.
NOTE:
• If the speaker's Bluetooth name does not appear on your Bluetooth device,
move the devices closer together. If that does not work, turn the devices off
and then on again before starting the pairing process again.
• When pairing the devices, make sure they are not more than 10 metres apart
and there are no physical obstructions between the devices.
• If you experience problems with connecting the devices, remove any existing
connections on your Bluetooth device and restart the pairing process.
• Once you have paired a device, the units should remember the connection
and you will not need to pair them again.
Disconnecting a Bluetooth connection
• In Bluetooth mode, press and hold the
on your device to disconnect. BT will flash and a sound prompt will play to confirm they
have been disconnected.
Connecting two speakers (TWS)
You can connect one MEGASOUND speaker to another MEGASOUND speaker via a Bluetooth
connection.
1. Place the speakers near to each other. The speakers must be within 10 metres when
using the TWS function.
2. Turn on both speakers and make sure they are in BT mode (BT will show on the screen).
3. Press and hold the
PAIRING will display.
4. When they are successfully connected, the master speaker will display HOST and the
secondary speaker will display SLAVE.
5. Connect the external Bluetooth device through its Bluetooth settings to the speakers.
Choose the pairing name of the master speaker (HOST). When the Bluetooth is connected,
a sound prompt will play.
6. Press and hold the
button or turn off the Bluetooth connection
button on one speaker. Both speakers will enter TWS mode. TWS
button on either speaker to exit TWS mode.
23
button to turn on the speaker. A
EN