Preparing For The Installation - Honeywell Home HE360 Notice D'installation

HE360 HUMIDIFIER
WELCOME
To the comfortable world of humidified air. When you use your humidifier, notice that your skin is not as dry, and
that your scratchy throat and irritated nasal passages that aggravate allergies and asthma are steadily
improving.
You have also taken the first step in reducing the zapping you create when you walk on your carpet and then
touch your TV, computer, metal door knob or your pet. Your furniture and woodwork are also benefitting from the
difference that humidified air makes.
Congratulations! You have just made a great investment in improving the comfort of your home.
INSTALLATION

Preparing for the Installation

Be sure you have the required tools and accessories from Table 1 and in the Suggested Tools and Accessories
list before beginning the installation.
Included Accessories
Suggested Tools and Accessories
Tools required for installation include:
• Tin snip.
• Screwdriver.
• Adjustable or open-end wrench.
• Drill, punch or awl.
• Level.
• 18 gauge, two-strand thermostat wire, 20 ft (6.2 m).
• 1/4 in. (6.35 mm) OD feed water tubing, 20 ft (6.2 m).
• 1/2 in (12.7 mm) ID drain tubing, 10 ft (3.1 m).
• Code-compliant 1/4" water shut-off valve and fittings.
Determining Best Location for Humidifier
CAUTION
Temperature and Static Pressure Hazard.
Can cause property or equipment damage.
Locate humidifier where ambient temperature is between 32°F (0°C) and 160°F (71°C).
Do not install humidifier where freezing temperatures could occur.
Be sure supply plenum static pressure is no greater than 0.4 in. wc and water pressure is no greater than
124 psi.
• Select a location for the humidifier on the supply (warm air stream) plenum. See Fig. 1.
• Select a location that cannot damage the air conditioner A-coil during installation.
• Do not locate the humidifier on the furnace body.
• Allow adequate clearance in front of and above the humidifier so you can easily remove the cover to perform
routine maintenance.
— Mount the humidifier at least 3 in. (78 mm) above the furnace body to allow adequate space for the
solenoid valve and drain line.
— Mount the humidifier in a conditioned space to prevent freezing.
69-2629EF—11
Table 1. Included Accessories.
Quantity
1 bag Connecting and mounting hardware:
Wire nuts (4)
No. 8 sheet metal screws (18)
Drain tube clamp
Feed tube mounting clamps (6)
Brass inserts (2)
Plastic compression rings (2)
1 Pressure switch
1 H6062 Humidistat
Accessory
2