Beko TBN6602W Manuel D'utilisation page 7

3 Operation
WARNING: Switch
A
appliance and disconnect from
supply before changing accessories
or approaching parts that move in
use.
1. Remove all packaging and stickers materials
and dispose of them according to the applicable
legal regulations.
2. Take the entire unit of the motor housing
(8) and place it on a level surface, e.g. on the
kitchen counter.
3. Now set the glass jug (4) with the opening
facing down on a level surface.
4. Remove the blade unit (6) carefully by turning
it counterclockwise and lifting it by holding it
from the sides of the unit.
A
WARNING: Do not remove the
blade unit by lifting it from the
blades.
WARNING: The blade unit is
A
very sharp! Handle the blade unit
with utmost care, especially during
cleaning, in order to avoid injuries.
5. Clean all parts, with the exception of the motor
housing as described in "Cleaning and Care".
6. Then re-assemble the jug blender in the reverse
order.
7. Put the glass jug D on the motor housing (8).
C
Make sure that the notches on the
bottom of the glass jug fit those in
the motor housing.
8. Cut the food into small pieces before using the
appliance.
Table Blender / User Manual
3.1 Blending
off the
1. Place the device on an even and dry surface.
The non-slip feet (10) ensure the stability of
the appliance.
2. Make sure that the power cord is disconnected
from the power supply and the control dial I is
on "0" before putting food into the glass jug (4).
3. Take the glass jug (4) from the motor housing
(8) by lifting the glass jug (4) upwards and open
the lid.
4. Now put the ingredients to be blended in the
glass jug (4). The ingredients should only be
about 2-5 cm long.
C
C
A
A
A
A
Add water to ensure the jug blender
functions smoothly.
Mix 3 units of hard food and 2 units
of water in order to have a smooth
jug blender experience
(i.e: 60 gr hard food 40 ml water).
WARNING: Do not put or blend
hot food or liquids in the glass jug.
If you process soup, make sure that
the liquid temperature does not
exceed 40°C.
WARNING: To process crushed
ice, we suggest you to start with
three quarters of ice in the jug and
add 15 ml of cold potable water.
WARNING: Don´t try to crush ice
without adding water to the jug.
WARNING: Never let the jug
blender operate while empty
(without food).
7 / EN