Cleaning The Filters - Mc Haus artic-40 Mode D'emploi

DRAINAGE OPERATION
The self-evaporating system uses the water collected to cool the condenser coils for better performance. It is not
necessary to empty the drain tank in COOL mode, except in DRY operation and in high humidity conditions.
For continuous or unattended operation in DRY mode, please connect a hose to
the drain outlet hole and make sure it is not kinked or obstructed, place the hose
outlet over a drain or bucket with a 20 degree or more inclination to the ground
and make sure that water can flow freely out of the unit. Do not immerse the end
of the hose in water.
MAINTENANCE
WARNING! Before cleaning, please turn off the air conditioning and disconnect the plug.
CLEANING THE SURFACE
Clean the surface of the air conditioner with a cloth or a soft, semi-damp cloth. Do not use chemical reagents. Doing
so will damage the surface of the unit and may even damage the air conditioner completely.

CLEANING THE FILTERS

If the air conditioner is used continuously, it is recommended to clean the filters once every two weeks.
1. Remove the air inlet grille and remove the filter
screen.
2. Use a hoover to clean the dust from the filter.
3. Rinse the air filter with water and let the water
run in the opposite direction of the air flow, let it
air dry before installing it.
Mc HAUS
artic-40
EN