Bercomac 700668 Feuille D'instructions

UNIVERSAL LIGHT ADAPTOR #700668
Install the light kit #700456-1 and the universal light adaptor #700668 according to the following instructions
Install the light assembly (item 1) on the light bracket
(item 2). Secure in place with a hex. bolt (item 3), flat
washer (item 4) and a hex nut (item 5).
Drill a hole with a 11/32'' bit at the appropriate place
to install the light.
Install the light onto the accessory with a 5/16''n.c. x
3/4'' hex bolt and the knob (item 1).
Adjust the light's angle and firmly tighten nuts and
knob.
Attach the wire to the bracket with a tie-wrap.
WARNING
TIE ALL THE WIRES:
Make sure the wires from the control assembly do
not interfere with anything on the tractor nor come
into contact with any heating, electrical or removable
elements of the tractor.
Tie the wires with nylon tie wraps included in the kit.
Connect the wire assembly (#106808) to the light
(item 1). Passe the wire to the dashboard of the
vehicle. Make sure that the wire never comes into
contact with any warm or moving parts.
Use the hook-it cable tie (item 2) to attach the wire to
the accessory and tie-wrap (item 3) to attach the wire
to the vehicle.
Fi-700668
INSTALLATION
1
Instructions sheet
2
1
:
3
M-11