Danby DFF349WDB Guide D'utilisation Et Soins De Propriètaire page 6

Installation Instructions
DOOR REVERSAL
INSTRUCTIONS
10) Remove the left door stop and screw for the freezer
door from the accessory bag and attach it to the
handle (see Figure 3 on following page) Note: The
left door and the right door stop of the freezer door
are different.
11) Replace the parts for the bottom hinge as shown
(see Bottom Hinge graphic Figure 6 on following
page). Tighten screws and replace the refrigerator
door.
12) Assemble the parts for the center hinge as shown and
tighten all screws (see Center Hinge graphic Figure
7 on following page) and replace the freezer door.
Figure 8.
1. Top Hinge Cover
2. Top Hinge Spindle
3. Top Hinge
Figure 7.
1
2
3
4
1.Center Hinge Spacer
2.Center Hinge
3.Screws
4.Bushing
Figure 6.
1
2
3
4
5
6
1.Door Stop
2.Door Stop Screw
3.Door Stop Pole
4.Bottom Hinge
5.Bottom Hinge Screws
6.Adjustable Foot
Top Hinge
1
2
3
Center Hinge
Bottom Hinge
13) Assemble the parts for the top hinge (see Top Hinge
graphic Figure 8). Do not tighten screws completely.
14) Line up the doors so that the bottom of the freezer
door aligns evenly with the top of the refrigerator
door. Tighten all screws.
15) Check all holes to make sure that hole plugs and
screws are in place.
16) Plug in refrigerator or reconnect power, reset the
controls (See "Operation" section) and return all
removable door parts and food to doors.
Figure 1
1
1.Cover Of Upper Hinge Holes
1
1.Door Hinge Hole Plug
1.Door Stop
2.Door Stop Screw
4
Figure 2
1
1.Hole Plugs
Figure 3
1
2
1.Left Door Stop
2.Door Stop Screw
Accessory
Bag
Figure 4
Figure 5
1
2